User manual

Fitting the Cooker Hood to the Wall

1. Fit the brackets with the round ends facing

downwards using the plastic rawl plugs and

screws provided.

2. Once the brackets are secured, lift the hood

squarely to the wall slightly higher than the

brackets. Lower the cooker hood until it is located

onto the two brackets.

Ensure that the cooker hood is correctly

located before letting go.

3. Access to the two wall levelling screws is from

above the hood. These are located in the two

extension arms at either side of the hood. Level

the hood using the screws located in each

extension arm.

4. By loosening the screws at the front of each

extension arm the hood can be aligned with the

front of the adjoining wall cabinets.

5. The hood should be secured on each side to the

adjoining wall cabinets using the 4 x 15mm (1/2

ins) security screws provided.

6. Adjust the lower spacer panel at the rear of the

hood to close the gap to the wall.

Decor Panel

The dimensions of the door panel should be

59.6cm (23 1/2 ins) wide by 35cm (13 3/4 ins) in

height.

Fitting a Decor Panel to the Hood

Visor

1. Remove the complete visor assembly by pulling

open into the operating position, simultaneously

press down on the release catch located behind

the visor on the left hand side of the casing.

2. Using the paper template provided, mark the

screw hole positions on the reverse side of the

decor panel. Ensure that the paper template is

aligned with the top edge of the decor panel.