User manual

25
Door reversibility
The side at which the door opens can be changed from
the right side (factory adjustment) to the left side, if the
installation site requires.
Warning! When changing the side at which the
door opens, the appliance may not be connected to the
mains. Remove plug from the mains beforehand.
Procced as follows:
To carry out the following operations, we suggest that
this be made with another person that will keep a firm
hold on the doors of the appliance during the operations.
Before carrying out any operations, remove the plug
from the power socket.
- Open the doors, unscrew and remove the middle
hinge (H) pulling away gradually from the refrigerator
cabinet, tilting slightly the two doors. pay attention to
remove the plastic spacer inserted under the hinge.
- Take off the freezer door pulling slightly downwards.
- Take off the refrigerator door pulling slightly upwards
the top.
- Remove the upper plastic plug of the freezer door
and reinsert on the opposite side.
- Remove the upper plastic plug of the refrigerator
door and reinsert on the opposite side.
- Unscrew the upper hinge pivot (G) of the refrigerator
and rescrew it on the opposite side.
- Remove with a tool the cover (e) unscrew the lower
hinge pivot (F) and rescrew on the opposite side
- Refit the cover (e) on the opposite side.
- Insert the middle hinge pivot into hole on the left of
the refrigerator door.
- Insert the refrigerator door on the lower hinge pivot
(f).
- Insert the freezer door on the upper hinge pivot and
tilt slightly the doors and insert the middle hinge pivot
into the hole on the left side of the freezer door.
- Opening the doors, fix the middle hinge on the left
side with two screws. Do not forget the plastic spacer
that must be placed under the middle hinge (H).
Pay attention that the border of the doors are parallel
to the top border.
- Unscrew the handles. Refit them on the opposite side
after having piercing the plugs with a punch. Cover
the holes left open with the plugs contained in the
documentation pack.
Reposition, level the appliance and connect it to the
mains socket.
In any case you do not want to carry out the above
mentioned operations, contact the nearest After Sales
Service Force.. The After Sales Service specialist will
carry out the reversibility of the doors at your cost.
Warning:
After having reversed the opening direction of
the doors check that all the screws are properly
tightened and that the magnetic seal adheres to
the cabinet. If the ambient temperature is cold (i.e.
in Winter), the gasket may not fit perfectly to the
cabinet. In that case, wait for the natural fitting of the
gasket or accelerate this process by heating up the
part involved with a normal hairdrier.
H
G
PR220