User manual

Fig. 3

The manufacturer declines all responsibility if

the accident prevention regulations are not

respected.

Fig. 4

To open the terminal box and reach the terminals

proceed as described below:

- insert the point of a screwdriver into the visible

protruding part of the terminal box;

- exert a light pressure and lift (fig. 4).

REPLACEMENT OF THE VOLTAGE CABLE

The connection of the voltage cable to the appliance’s terminal box is of type “Y” which signifies that its

replacement requires the specific equipment of a technician. If the replacement of the cable is necessary, use

only cables type H 05 VV H2-F O T 105; in both cases, the cables must be of sections suitable to the voltage

and able to support the working heat. Furthermore it is necessary that the yellow/green earth wire be

approximately 2 cm longer than the phase wires (fig.3). After connection try out the heating elements by

allowing them to function for about three minutes.

This appliance conforms to Directive EEC N. 87/

308 of 2.6.87 relating to the abolition of radio

interference.

FO 0287

FO 0073

Neutral

Earth wire (yellow - green)