User manual

17
Door reversibility
1. Unplug the appliance from the power supply
before carrying out the below-mentioned
operations.
2. Remove the ventilation grill (D).
3. Unscrew the bottom hinge (E).
4. Remove the freezer door by releasing it from the
middle hinge (H).
5. Unscrew the middle hinge.
6. Remove the fridge door by releasing it from the
top hinge pin (A).
7. Remove the pin and the washer (A+B) from the
top hinge (C), then mount these on the opposite
side, after having removed the plugs which must
be refitted on the other side.
8. Refit the fridge door.
9. Replace the middle hinge to the left hand side.
10.Replace the freezer door.
11.Screw down the bottom hinge (E) on the opposite
side by using the screws previously removed.
12.Remove the plug (F) from the ventilation grill (D)
and replace it on the opposite side.
13.Re-assemble the ventilation grill (D).
14.Unscrew the handle. Refit it on the opposite side.
15.The doors can be aligned by adjusting both the
middle and top hinges.
16.The middle hinge can be adjusted horizontally,
with the help of a tool, after having slackened the
two screws.
17.The top hinge is adjusted by slackening the nut
with a 10 mm spanner and then proceeding as
shown in the Figure.
18.Dismantle the handles and reassemble them on
the opposite side. Cover the holes left open with
the plugs contained in the documentation pack.
Attention
After completion of the door reversing operation,
check that the door gasket adheres to the cabinet. If
the ambient temperature is cold (i.e. in Winter), the
gasket may not fit perfectly to the cabinet. In that
case, wait for the natural fitting of the gasket or
accelerate this process by heating up the part
involved with a normal hairdrier.
E
F
D
F
F
F
C
B
A
D736
D737
H