Installation Foreword If you are discarding an old refrigerator that has a lock on the door, please ensure that the lock is made unusable to avoid accidents to young children, Electricity Supply The appliance is for operation on a 220/240 V. 50 Hz supply, so be sure that your electricity supply voltage is within the range marked on the nameplate located inside the cabinet. Earthing 'WARNING: THIS APPLIANCE MUST BE EARTHED.The manufacturer declines any liability should this safety measure not be observed.
Location and leveling Place the appliance sway from heat sources and in such a way that air can circulate freely to the back and around the top of the cabinet. Level by adjusting the special leveling feet, on the bottom of the cabinet. Before using Remove all securing tapes. Wash inside the appliance with lukewarm water and a Tittle bicarbonate of soda (one teaspoonful to one quart of water), Do not use soap or detergent as the smell might linger. Dry thoroughly.
Operation Refrigerator Starting-up “Temperature Regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the upper right side of the inner liner, clockwise beyond the position (stop} o start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. A medium setting is generally the most suitable.
compartment. Meat ean only be stored safely in this way for two or three days at the most. Cooked food, cold cuts, jelly, tee: these should be well covered and can be stored on anyone of the shelves.
Maintenance Prior to undertaking any maintenance operation, be sure to unplug the appliance from the wall socket as a safety precaution. Clean out the interior periodically with lukewarm water and some bicarbonate of soda, the cabinet exterior with a Silicone wax spray, the condenser and the motor compressor with a brush or a vacuum deanery.
Door reversal directions rice) Before carrying out the operations described below, pull out the mains plug from the wall socket. Proceed as follows: a. To take off the table top, first remove the two rear fixing screws (1), then slide it out from slots (7). b. Remove the upper hinge (2). ¢. Slide out the door (8). d. Remove pivot (3) from hinge (2) and refit it in the corresponding hole on the opposite side. e. Replace the hinge (2) on the opposite side. {.
Gaussian Electromagnetic spa GAUSSIAN GUARANTEE CONDITIONS This guarantee is in addition to your statutory and other legal rights which will not be excluded or in any way diminished by the rectum of the enclosed card.