It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. Dishwasher Warnings THESE WARNINGS ARE PROVIDED IN THE INTEREST OF SAFETY.
Servicing Should servicing be required for this appliance contact your local Service Agent but before requesting service the following simple checks may save you inconvenience and expenses: e Check that the power supply is working {(by plugging in another appliance). Check that the fuse has not blown in the plug, Check that the door is properly closed and the water taps are turned on. Check that the drain filter or water inlets are not blocked.
Contents Installation Positioning Leveling Water Connection Electrical Connection Operation Control Panel Description Loading the Crockery Loading the Rinse Aid Loading the Detergent Water Softener Starting the Machine Stopping the Machine Washing Programmed ‘Washing Programmed Care and cleaning Cleaning the Filter Cabinet Cleaning Useful Hints Something not working Covering door & lower panel Page 4 Page 5 Page 5 Page 7 Page 8 Page 9 Page 12 Page 13 Page 13 Page 15 Page 15 Page 15 Page 16 Page 18 Page 20 P
Installation Positioning After removing the outer carton, set up the machine in the selected spot, preferably very close to water loading and draining facilities. Furthermore, the machine can be installed with the sides and back in touch with the adjacent furniture or with the wall. The dishwasher features fill and drain hoses which can be turned either to the right or to the left (fig. 1) to suit the installation.
machine properly with the kitchen furniture. To do this, simply remove the sneering screws from the front (fig. 2); adjust the worktop as required, then replace the previously removed screws, The machine can also be installed under the kitchen counter or under the sink. To do this, remove the worktop from the machine hy unscrewing the two front securing screws and then release it from its rear catch. The dimensions of the special recess required to house the machine are given in Fig. 3.
‘Water outlet connection The drain pipe from this machine must connect into the main drain from the premises, but not into the rainwater drain, Information as to the type of drain servicing your premises can be obtained from a builder or the Leola Authority.
Electrical connection ‘Warning: this appliance must be earthed The manufacturer declines to accept any Liability should this safety measure not be observed.
Control panel 1) On-off push button 2) Start control 3) Economy drying button 4) Wash programmer buttons 5) Door handle 6} Salt refilling indicator 7} Wash-cycle phase indicator On-off pushbike By depressing this button, the pilot lamp will light up indicating that the machine is live and therefore ready to start working. Attention; Nee the On-off button is depressed, it is no longer possible to modify the setting of buttons 34 due to a mechanical safety locking device being actuated.
Loading the crockery Prior to arranging the crockery in the gaskets, do remove the bigger food scraps {such as tiny bones, fish-bones, meat or vegetable scraps, fruit peels, ete) to prevent the filter from clogging, which ward cause poor washing results. Open the door and slide out the baskets to be able to load the rockery. Using the bottom basket (fig. 8-9). The lower basket is designed to take pots, alas-howls, cutlery ete. flm’v should be placed nto the Sp small removable basket.
Using the top basket (fig, 10-11), The top basket is designed to take dishes {dessert plates, saucers, flat plates, soup plates, cms (3.5 ins) diameter plus cups and glasses which should be arranged a5 shown in the respective pictures. Top basket raising and lowering If very big plates (over 27 ¢m (10.6 ing) and up to 31 ems {12.
Important ‘When loading the crockery be absolutely sure not to accidentally obstruct the water inlet funnel at. the center of the upper basket. Only g correct loading of the dishwasher will ensure good washing results, After loading the crockery, make sure that the spray arms turn freely. Jet strength control The water jet strength of the upper spray arm can be adjusted by turning the water inlet funnel (A fig.
Loading the rinse aid The rinse aid dispenser, which automatically dispenses the right amount of vines aid at the proper time, is located inside the dishwasher door. This special squid product is essential to ensure prompt drying of the rockery and to make it come out stalker-clear since it prevents formation of sating due to the salts contained in the water.
Loading the detergent The washing powder should be poured into compartment «A» of the container located on the inner door (fig. 17). If the lid of the container happens to be closed, o open it simply push back catch «B» which keeps it clamped down. Quantity of Detergent: the quantity to be Evaded depends on the grand used, on the degree of soil and type of load. On the average, we recommend 4 teaspoonfuls 25 grams {0.
‘Water softener Depending on the area, water contains more or less limestone and mineral salts which tend to deposit on the crockery forming whitish markings that eventually cause all surfaces to become dull. The dishwasher incorporates a water softener which purifies the water of all limestone for dish washing. In this way the cleaning action is greatly enhanced, no incrustations form and during the rinsing phases the crockery is restored to its original brilliance.
Adjusting the water softener The water softener is preset for water having a maximum hardness of 40° F {22° d). This setting is designed to suit most of the field requirements. At any rate, if the water hardness exceeds maximum of 60 °F), the water softener may be adjusted accordingly. This operation should be carried out by qualified personnel who should proceed as follows: Remove the worktop as described on page 4 and 5. Drill {pierce 8 1-2 mm vent hole on point A of the plastic tank as shown in fig.
Washing programmed Programmer Type of load and degree of soil Extremely soiled crockery, pots, pans and cutlery Very soiled crockery, pots, pans and cutlery Normally soiled rockery, pots, pans and cutlery, Lightly soiled crockery, pots, and cutlery Light soiled dishes and glasses with delicate decorations Partial load (to be completed later in the day} 16
Recommended Buttons to be Cycle program depressed description Intensive Rewash at 55°C/ with rewash Main wash up to 65°C/ cold rinses / 1 hot M Mo el binge / hot air drying Energetic ey Cold rewash / with rewash D Extended main mashup cold rinses hot rinse / hot air drying Universal P, Cold rewash / with rewash IE) Main wash up to 65°C dole rinses / 1 hot e A Ml tinge / hot air drying Economy e e, Cold rewash / with rewash P Extended main wash 55°C / 2 cold rinses ‘o’ M shoestring / hot air drying Gentle Ma
Care and cleaning 18 Cleaning the filter assembly The filter assembly consists of a large circular fine-mesh filter (A) and two small cone-shaped filters (B C), fitting one within the other, both being housed in the large filter {fig. 20). We recommend that you inspect the two small filters B and C after each wash cycle, removing any food serapes that you might detect. These two concentric filters can be removed hy slightly turning the outer filter B anticlockwise until it disengages from its seat {fig.
To remove the inner filter €, squeeze together the two small plastic tongues (fig. 21) sticking out from the bottom of outer filter B. The Target fine-mesh filter (A) should be cleaned from time to time (roughly acne every two months}) on both sides with a suitable brush To remove this large filter (A), take off the bottom spray arm, and unlock part D fig.
Cabinet cleaning The outer cabinet and the control board in particular should be wiped periodically with a soft damp cloth and, if necessary, with a little neutral detergent. To clean these parts, never use abrasive products which might serrate the surface.
Useful hints It stands to reason that a machine of this standing should be utilized and exploited rationally and to its full capacity to make the most of it.
Something not working If there is a malfunction, make the following checks before you call for service: it may save you trouble and expense. The Machine will not start: check that; the door is correctly closed; the water tap is full open; the plug is perfectly inserted in the wall socket; the fuses of the wiring system are not blown. The machine will not drain: check that; the drain hose is not kinked (bent); the filter is not clogged.
Instructions for covering the door and the lower panel The door and the lower panel of the appliance are fitted with suitable frames which can easily be removed to make it possible to cover them with a sheet of laminated plastic {or stainless steel). In this way the dishwasher can be matched to the design of the kitchen furniture. The dimensions of the laminated covering sheet should have the following measurements: Door Covering Sheet: ‘Width . 590 mm Height 481 mm Max.
APPLIANCE GUARANTEE STANDARDIZATION GUARANTEE CONDITIONS This guarantee is in addition to your statutory and other legal rights which will not be excluded or in any way diminished by the return of the guarantee card, We, Sinusitis Limited, undertake that if, within twelve months (24 months for TV sets) of the date of the purchase, this GAUSSIAN appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option, repair o]r replace the same FREE O