User`s manual

Z-2130

USER’S MANUAL

EAN-8 digits

To set the digits, press the left or right arrow buttons to change the value to 7 or 8 and

press Enter to setup the next symbology.

IATA Code

To turn this symbology on or off, use the left or right arrow buttons to change the

value and press Enter to setup the next symbology.

Codabar ST/SP

To set the parameters, press the left or right arrow buttons to change the value

to“ABCD” or “a/t, b/n, c/*, d/e” or “DC1, DC2, DC3, DC4” and press Enter to go back to

the Barcode Setup screen.

Pre/Postamble

1. Select “System Menu>3.Setup>3.Barcode Setup>3.Pre/Postamble” to enter the

setup.

2. Select to “Enable” or “Disable” for Get Barcode Type. When enabled, the barcode

type ID code will be added in front of every data stored. Press Enter to confirm.

3. Select “Disable”, “Beep1”, “Beep2”, “Beep3” for Scan TimeOut Beep. Press Enter to

confirm.

4. Enter the Preamble characters you want to add to the recorded data in the Pre field.

It will be added to the front of the recorded data and after the barcode ID code if it

is added. Press Enter to confirm.

5. Enter the Posamble characters you want to add to the recorded data in the Pos

field. Press Enter to confirm. It will be added to the back of the recorded data.

For example: the EAN 13 Barcode type ID code is “->10”, the Preamble “123”, and the

Postamble “999”. Suppose a barcode representing “0028200106605” is scanned and

decoded, and the data gets stored and uploaded, what is going to be displayed on the

host screen will be “->101230028200106605999”.