INSTALLATION AND INSTRUCTION MANUAL INSTRUÇÕES DE INSTALAÇÃO E UTILISAÇÃO INSTRUCCIONES PARA INSTALACION Y USO TUMBLE DRYER SECADORA SECADOR TCS 674 E 125996800
CONTENTS Warnings ................................................Page 3 Description of the appliance ........Page 4 Installation .............................................Page 5 ■ Positioning.................................................Page 5 ■ Door reversal .............................................Page 6 ■ Electrical connection .................................Page 6 ■ Stacking kit ................................................Page 6 Use .....................................
ENGLISH WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety.
i DESCRIPTION OF THE APPLIANCE 345 6 7 1 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 Top cover Water container/programme chart Door opening button Low temperature button Buzzer OFF button Start button Control lights Programme selector dial Mains-on light Fluff filter Lock Rating plate Ventilation grid Condenser Adjustable feet EXTRA 2 TORRT A 8 9 BOMUL L LINNE SKÅPST ORRT B STRYKT Tidsinstä lld torkning ORRT C från 20 till 90 SYNTE T SKÅPST ORRT minuter D A U T O R E V E R S E TC
ENGLISH INSTALLATION Positioning It is recommended that, for your convenience, the machine is positioned close to your washing machine. The tumble dryer must be installed in a clean place, where dirt does not build up. Air must be able to circulate freely all round the appliance. Do not obstruct the front ventilation grille or the air intake grilles at the back of the machine. To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface.
Door reversal To make it easier to load or unload the laundry the door can be reversed. This operation must be carried out by qualified personnel. Please contact the nearest Zanussi Service Centre. Electrical connection This machine is designed to operate on a 220230 V, single-phase, 50 Hz supply. Check that your domestic electrical installation can take the maximum load required (2.2 kW), also taking into account any other appliances in use.
ENGLISH USE Control panel TCS A U T O R E V E R S 1 2 3 4 5 1 Programme Chart This will help you to select the correct time or programme for drying. 2 Water container When the tumble dryer is being used, condensation is collected in a special container. To empty container, please refer to ‘Maintenance’ chapter.
11 Programme selector dial The selector dial allows you to select the desired programme or time. Automatic drying (electronic programmes) The appliance operates in these programmes by means of dampness sensors. All you have to do is to set the selector dial to the programme required (A, B, C or D), according to the type of laundry and the degree of drying required (see programme table). Time controlled drying You can select a time up to 90 mins.
ENGLISH Programme Table Automatic drying (electronic programmes) Type of laundry Cotton Synthetics Degree of drying required Max. load Programme selector setting Extra dry 5 kg A Store dry 5 kg B (*) Iron dry 5 kg C (*) Store dry 2 kg D (*) (*) According to CEI 1121 Standards Time controlled programmes Cotton Degree of drying required Spin speed 800 - 1000 r.p.m. Store dry 1000 - 1200 r.p.m. 800 - 1000 r.p.m. Iron dry 1000 - 1200 r.p.m. Max. load Drying time 3.5 kg 75 - 90 min.
i Drying sequence Before starting up for the first time it is advisable lo load a few moist cloths into the dryer and to let it run for about 20 minutes. This ensures that no dust and dirt is left in the drum. 1. Load the laundry Open the door by depressing button . Load the items one at a time, shaking them out loosely and close the door. 2 Select drying programme or time Turn the programme selector dial to the programme letter or time, the mains-on light illuminates.
■ ■ ■ Useful hints Try to load to the maximum capacity of the machine as small loads are uneconomical. For information, here is a list of the average weights of some common laundry items.
MAINTENANCE You must disconnect the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. External cleaning Use only soap and water and then dry thoroughly. From time to time, apply a little wax furniture cream with a soft cloth. Important: do not use methylated spirit, diluents or similar products. Cleaning the filter Your dryer will only function well if the filter is clean.
ENGLISH Cleaning condenser Remove fluff from condenser on a regular basis to avoid prolonging drying times and increasing energy consumption. Proceed as follows: 1. Remove condenser by using the top handle. 2. Clean condenser with a hand-held shower or a soft brush. 3. Clean external part, too. 4. Remove the fluff from the seal of the condenser in the lower part of the inner door. 5. Leave condenser to dry; when it is dry, place in original position.
SERVICING Before contacting your local Zanussi Service Centre, please make the following checks: PROBLEM ■ The dryer does not start up POSSIBLE CAUSE ■ ■ ■ ■ ■ ■ ■ The dryer does not dry properly ■ ■ ■ ■ ■ ■ ■ ■ If, after the above checks, there is still a fault, call your local Zanussi Service Centre. Please make sure you give the model and serial number of the appliance. This information can be found on the rating plate. 14 The door is open. The plug is not fitted into the wall socket.
ANOMALIAS DE FUNCIONAMENTO Antes de contactar o Centro de assistência Zanussi da zona, efectue os seguintes controlos: PROBLEMA ■ Se o secador não funcionar: CAUSA POSSIVEL ■ ■ ■ ■ ■ ■ ■ Se o secador não seca correctamente: ■ ■ ■ ■ ■ ■ ■ ■ A porta está aberta A ficha não está inserida na tomada. Não há corrente eléctrica O selector de secagem não está posicionado correctamente. O recipiente da água está cheio. A tecla de arranque não foi premida. O filtro está entupido.