Instruction for the use and care of SL. 24 washing machine Z Ifs notwork do s the woy that we do't.
TECHNICAL DATA Width . Overall depth {excluding hose} Height Weight Dry clothes capacity . Heater rating or rating during washing Motor rating during spinning Water load Minimum water pressure . Maximum water pressure Supply Voltage 236 ins. 220 ims, 335 ins. 193.5 Ibs. g Ibs. 2500 w 007 HP 0.16 HP 31 gals. 7 psi. [ 48 Nw/em?) 10 p.s.i.
INSTALLATION UNPACKING After having removed the cardboard packing, reinforcing angles and polythene wrapping, proceed as follows: 1) it the machine and remove base packing {fig, 1). 2} Remove back panel and bracket securing motor to back of the appliance (fig. 2} 3) Remove the B screws securing the top of the machine and lift off. 4) B Remove the screws and nuts which fix the transit bar {fig. 3) to the cabinet 5) Replace top and back panel.
important that special care is taken in leveling the appliance in order to avoid any vibration or movement during operation. When positioning the machine, a small space must be allowed all round, so that it cannot touch the walls or adjacent furniture while it is operating. WATER CONNECTION Water inlet hose: if a cold water tap having a %" gas thread spout is available, the inlet hose fitted with the rubber sealing washer (supplied with the machine] should be connected as shown (fig. 5).
i the water connection js made onto new pipes or onto pipes which have not hen used for a long time, it is advisable to run off a certain amount of water before connecting the machine. This will avoid foreign matter blocking the filters placed at the end of the water inlet hose. Drain hose: Hook the curved end of the outlet hose over the edge of a sink or insert it into a drain pipe not less than 20 ins. and not more than 39 ins. from floor level (fig. 6).
ELECTRICAL CONNECTION WARNING: THIS APPLIANCE MUST BE EARTHED Connection to the electrics) supply should be made by a 3 pin 13 Amp or 3 pin 15 Amp plug, If a2 BS 1363 3 pin 13 Amp fused plug and socket is used, the plug should be fitted with a 13 Amp fuse. if a 15 Amp plug and socket is used this should be protected by a 15 Amp fuse either in the plug or at the distribution board fuse box. The manufacturer declines any ability should this safety measure not be observed. .
machine is started, it will automatically carry out all operations up to the end of the programmer chosen and will automatically stop. To switch the machine off or stop the machine in the course of a programmer, push in the timer control knob. As a safety feature the door |s automatically locked during the washing cycle and remains stocked for a further 60-70 seconds after the machine finishes the programmer or is switched off. This feature is not however operative during the water filling stage.
main wash (344 oz) should be put anti section « B ». For biological washing of synthetic material, use the specific powders which are available on the market and read the manufacturer's instructions carefully. Once the dispenser drawer is filed, close by pushing in. « INTENSIVE WASH » PUSH BUTTON it is advisable to depress push button when washing shirts or tablecloths having particularly hard-to remove stains as this will give a vigorous washing action even on the delicate cycles.
WASH PROGRAMMED COTTON, LINEN 1 Whites-heavy soil bio rewash Long rewash and soaking in lukewarm water, Vigorous wash in very hot water. 5 rinses in cold water. Spinning. Put the powder required for bio-rewash and soaking into compartment «a» and for the main wash into compartment required, the liquid additive into compartment « ¢ =, Whites-heavy spit Rewash in lukewarm water. Vigorous wash in very hot water. 5 rinses in cold water, Spinning.
WASH PROGRAMMED Non-fast coloreds Vigorous wash in lukewarm water. 5 rinses in cold water. Spinning, Put the powder required for the wash into compartment required, pour the liquid additive into compartment «c». Rinses 6 5 rinses in cold water. Spinning. Special Treatments Spinning. Pour the liquid additive into compartment « ¢ » taking care not to exceed the level of the filter, r Rinse with cold water and additive. Spin Spinning for about 5 minutes with water draining.
WASH PROGRAMMED SYNTHETICS, WOOL, DELICATE Note: There Is no water draining in the last rinse of the following cycles to prevent the clothes from creasing if they are left in the machine at the end of the wash. To drain the water, turn the timer knob to the symbol Ej 9 White nylon heavy soil Rewash in lukewarm water. Gentle wash in hot water, . 3 rinses in cold water. No spinning.
CARE AND CLEANING Make sure that the plug has been removed from the socket prior to undertaking any kind of maintenance. From time to time, carry out a complete cycle without a washing load, adding 1 oz. of Glucagon. This operation should also be effected when the washer has been out of use for a long time. eave the door ajar for a couple of hours or so after the wash to allow air to circulate freely inside the machine.
HINTS FOR CARE OF WASHING POWDER DISPENSER We recommend that the washing powder dispenser is checked regularly to ensure that it is clean and dry. Do wipe the dispenser after each wash, Should the dispenser require special cleaning, the drawer can be completely removed, and the interior cleared of any deposit. The drawer can be removed from the front of the appliance by giving a sharp pull outwards. A sharp tap with the palm of the hand may be necessary when replacing the drawer.