Operating instructions

19 Manual Module M-G1 33300

release the button, and the ﬁ rmware update process commences.

If the device is not recognised, if the pop-up window “Target device ID not found” appears, or if the

process fails before 100% is reached, you must restart the update procedure. Repeat all the steps as

described above.

The Status display and the Progress bar show the progress of

the ﬁ rmware update. The update is completed when the mes-

sage “Complete…100%” or “Complete!!” appears.

During the update process both LEDs on the transmitter glow

constantly. When it is complete, the red LED goes out and you

will hear a brief conﬁ rmation melody. Both LEDs on the receiver

also light up; when the process is complete, the green LED

goes out, and the red LED starts ﬂ ashing.

Switch your transmitter / receiver off, and disconnect the ad-

apter lead.

Caution: after completing an update process, you must in-

itialise the device before using it, i.e. reset it to the factory

default values.

Initialisation:

To initialise the transmitter, or to reset it to the factory default settings, press and hold the BIND / RAN-

GE button on the module while you switch the transmitter on, then release the BIND / RANGE button

again.

Please note:

When initialisation is complete, the transmitter will be in Fail-Safe set-up mode. You can therefore imme-

diately continue by programming your fail-safe settings.

If you previously set your transmitter’s Country setting to “France” mode, you must also re-enter the

Country setting.