Operating instructions

ManualsBrandsZanussi ManualsKitchen AppliancesMC19 M

Manual Module M-G1 33300 12

5.2.6 Servo test (RX SERVO TEST)

To switch to the Servo test display, press the ENTER button repeatedly until RX SERVO TEST appears

on the screen

Display-Anzeige Erläuterung Einstellungen

ALL MAX Maximum control surface travel position for all servos 1500 – 2000 usec

ALL Min Minimum control surface travel position for all servos 1000 – 1500 usec

TEST Test procedure START / STOP

ALARM VOLT Displays the set voltage at which the low voltage

warning signal is triggered

3.0 – 6.0 V

Factory setting 3.8 V

ALARM TEMP+ Displays the upper limit value at which the warning

signal is triggered

50 – 80° C

Factory setting 70°C

ALARM TEMP- Displays the lower limit value at which the warning

signal is triggered

-20 – +10° C

Factory setting -10°C

CH OUTPUT TYPE Channel sequence ONCE / SAME / SUMI

/ SUMO

Maximum control surface travel position (ALL MAX): this is where you set the maximum control

surface travel for the servo test

Minimum control surface travel position (ALL min): this is where you set the minimum control sur-

face travel for the servo test

Test procedure (TEST): START initiates the servo test process; STOP halts it again. You start and stop

the test by simultaneously pressing the INC / DEC buttons (dark background disappears)

Receiver low voltage warning (ALARM VOLT): monitors the receiver voltage, and can be set to any

value within the range 3.0 to 6.0 Volt. If the voltage falls to the threshold value, an audible signal is

emitted (continuous beeping), and “VOLT.E” ﬂ ashes at top right in all the Smartbox’s receiver displays;

at the same time the parameter R-VOLT is displayed in inverse form in the receiver data display (RX

DATAVIEW).

Receiver temperature monitor (ALARM TEMP +/-): monitors the receiver temperature. It is pos-

sible to program both a lower limit value ALARM TEMP- (-20 – +10°C) and an upper limit value

ALARM TEMP+ TEMP (50 – 80°C). If the receiver temperature rises above the maximum value or falls

below the minimum, the unit generates an audible warning (continuous beeping). At the same time all

the Smartbox receiver displays show a ﬂ ashing “TEMP.E” at top right, and the parameter R-TEM is

shown in inverse form in the receiver data display (RX DATAVIEW).

It is important that the temperature of your receiver always stays within the approved range under all

ﬂ ight

conditions (ideally between 10 and 55°C; please refer to your RC system instructions). If the tempera-

ture rises above maximum or falls below minimum an audible signal is emitted (continuous beeping)

Channel- (CH OUTPUT TYPE): at this point you can select how the receiver signals are sent to the

outputs.

ONCE: the receiver outputs are transmitted in sequence: recommended for analogue servos. This set-

ting ensures that the servos are automatically operated using a 20 msec cycle - 30 msec in the case

of the twelve-channel receiver (Order No. 33512) - regardless of the value set and displayed in the RX

RX SERVO TEST <

ALL-MAX : 2000usec

ALL-MIN : 1000usec

TEST : STOP

ALARM VOLT : 3.8V

ALARM TEMP+ : 70°C

ALARM TEMP- : 10°C

CH OUTPUT TYPE: ONCE

INC + DEC

INC

DEC

ENTER

ESC