32992220•copertina.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 2 (Nero/Process Black pellicola) Dear customer, Transport damages Please read these operating instructions carefully and pay particular attention to the safety notes indicated in the first pages. We recommend that you keep this instruction booklet for future reference and pass it on to any future owners. When unpacking the appliance, check that it is not damaged. If in doubt, do not use it and contact the Service Centre.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 3 (Nero/Process Black pellicola) The following warnings are provided in the interests of overall safety. You must read them carefully before installing or using the appliance. Installation • Leave the porthole door slightly ajar when the appliance is not in use. This preserves the door seal and prevents the formation of musty smells. • All internal packing must be removed before using the appliance.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 4 (Nero/Process Black pellicola) Disposal Packaging materials The materials marked with the symbol recyclable. Machine are Use authorised disposal sites for your old appliance. Help to keep your country tidy! >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 5 (Nero/Process Black pellicola) Unpacking 6. Set the machine upright and remove the remaining rear screw. Slide out the relevant pin. All transit bolts and packing must be removed before using the appliance. 7. Plug all the holes with the plugs which you will find in the envelope containing the instruction booklet. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 6 (Nero/Process Black pellicola) The other end of the inlet hose which connects to the machine can be turned in any direction. Simply loosen the fitting, rotate the hose and retighten the fitting, making sure there are no water leaks. The drain hose must not be kinked. P1118 For a correct functioning of the machine the drain hose must remain hooked on the proper support piece situated on the top part of the back side of the appliance.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 7 (Nero/Process Black pellicola) This new machine meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. • The temperature selector dial will allow you to choose the most suitable temperature for your laundry. • The automatic cooling of the washing water from 95° to 60°C before draining will prevent old drain pipes from being deformed.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 8 (Nero/Process Black pellicola) Use Control panel FV 825 N B 60°- 95° B 30°- 60° B 40°- 60°E A 60°- 95° C 60° D 40° F G J 30°- 60° - 40° K - 40° L H 30°- 60° M N P ELECTRONICTEMPERATURECONTROL 1 2 3 4 5 6 7 1 Detergent dispenser drawer 8 9 6 Intensive rinse button Can be used only for cotton programmes A-B-C-D-F. The machine will perform the rinses with more water.
4/9/03 10:16 AM Pagina 9 (Nero/Process Black pellicola) Washing hints ENGLISH 132992220 gb.qxd Laundry weights The following weights are indicative: Sorting the laundry bathrobe Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. Temperatures 95° 60° for normally soiled white cottons and linen (e.g. tea cloths, towels, tablecloths, sheets...
132992220 gb.qxd 4/9/03 10:16 AM Pagina 10 (Nero/Process Black pellicola) Red wine: soak in water and detergent, rinse and treat with acetic or citric acid, then rinse. Treat any residual marks with bleach. Follow the product manufacturer’s recommendations on quantities to use and do not exceed the «MAX» mark in the detergent dispenser drawer.
4/9/03 10:16 AM Pagina 11 (Nero/Process Black pellicola) Operating sequence 4. Select the desired option Before the first wash we recommend that you pour 2 litres of water into the main wash compartment of the detergent drawer in order to activate the ECO valve. Then run a cotton cycle at 60°C, with the machine empty, in order to remove any manufacturing residue from the drum and tub. Pour half a measure of detergent into the main wash compartment and start up the machine.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 12 (Nero/Process Black pellicola) 7. At the end of the programme The machine stops automatically. The mains on light goes out. Turn the drum by hand to make sure it is completely empty, so as to avoid any forgotten items being damaged in a subsequent wash (e.g. shrinking) or their colour running into a load of whites.
2992220 gb.qxd 4/9/03 10:16 AM Pagina 13 (Nero/Process Black pellicola) Washing programmes for cotton and linen Max. load: 4 kg Progr. Temp.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 14 (Nero/Process Black pellicola) Programme table Washing programmes for synthetics, mixed fabrics, delicates and wool Max. load: 1.5 kg, wool 1 kg Progr. Temp.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 15 (Nero/Process Black pellicola) Bodywork Drain pump Clean the outside of the machine with soap and water only. Rinse with clean water and dry with a soft cloth. The pump should be inspected if • the machine does not empty and/or spin • the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump. Important: do not use methylated spirits, solvents or similar products to clean the bodywork.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 16 (Nero/Process Black pellicola) • clean the pump if necessary as previously described; • Put the cap back on the emergency emptying hose and place the latter back in its seat. • replace the emergency emptying hose in its seat after having plugged it; • screw the pump again and close the door. Frost precautions If the machine is installed in a place where the temperature could drop below 0°C, proceed as follows: P1117 • Screw the pump fully in.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 17 (Nero/Process Black pellicola) Problems which you can resolve yourself. Problem Possible cause • The machine does not start up: • The door is not firmly closed. • The machine is not plugged in or there is no power at the socket. • The main fuse has blown. • The programme selector dial is not positioned correctly. • The ON/OFF button has not been depressed. • The machine does not fill: • The water tap is closed. • The inlet hose is squashed or kinked.
132992220 gb.qxd 4/9/03 10:16 AM Pagina 18 (Nero/Process Black pellicola) Problem Possible cause • Water is not visible in the machine: • The machine, which is the result of modern technology, runs in a very economical way with low water consumption. Performance is nevertheless excellent. • The door will not open: • The programme is still running. • The door lock has not been released. • There is water in the drum.
