EN User manual Freezer ZFT11100WA ZFT11100XA
Contents Safety instructions _ _ _ _ _ _ _ _ _ _ _ _ _ _ Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Helpful Hints and Tips _ _ _ _ _ _ _ _ _ _ _ _ 2 4 5 5 6 Care and cleaning _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 7 Installation _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 9 Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 11 Environmental concerns _ _ _ _ _ _ _ _ _ _ _ 1
If the refrigerant circuit should become damaged: – avoid open flames and sources of ignition – thoroughly ventilate the room in which the appliance is situated • It is dangerous to alter the specifications or modify this product in any way. Any damage to the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. 1. 2.
• It is advisable to wait at least four hours before connecting the appliance to allow the oil to flow back in the compressor. • Adequate air circulation should be around the appliance, lacking this leads to overheating. To achieve sufficient ventilation follow the instructions relevant to installation. • Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn.
7. setting chosen and will stay out to indicate that everything is in order. It will come on if the freezer temperature rises unduly for instance, after opening the freezer door or placing food inside the cabinet, but the light should go out again when the temperature returns to the correct storage level. When the appliance has reached the set temperature (the Red Indicator Light has gone out) adjust the Temperature Regulator according to the quantity of the stored foods. Switching off 1.
Helpful Hints and Tips Normal Operating Sounds • You may hear a faint gurgling and a bubbling sound when the refrigerant is pumped through the coils or tubing. This is correct. • When the compressor is on, the refrigerant is being pumped around and you will hear a whirring sound and a pulsating noise from the compressor. This is correct. • The thermic dilatation might cause a sudden cracking noise. It is natural, not dangerous physical phenomenon. This is correct.
Important! Take care of not to damage the cooling system. Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. 4. 5. 6. 7. When defrosting is completed, dry the interior thoroughly and keep the scraper for future use. Switch on the appliance. Turn the Temperature Regulator to the Full Loaded position and leave to run for at least 8 hours.
Important! There are some sounds during normal use (compressor, refrigerant circulation). Important! The appliance operates discontinuously, so the stopping of compressor Problem does not mean being no current. That is why you must not touch the electrical parts of the appliance before breaking the circuit.
Problem Possible cause The appliance does not cool at all Solution There is no voltage in the mains socket (try to connect another appliance into it) Call an electrician Plug is not connected to the mains socket properly Connect the mains plug properly There is no voltage in the mains socket (try to connect another appliance into it) Call an electrician The appliance is not switched on Switch on the appliance Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door.
mm to allow the door to open enough so that the shelves can be removed. Warning! It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. Door reversibility min. 100 mm 15 mm 15 mm Important! To carry out the following operations, we suggest that this be made with another person that will keep a firm hold on the doors of the appliance during the operations.
A 1. B C D E Important! The wires in the mains lead are coloured in accordance with the following code: A Green and Yellow: Earth C Brown: Live D Blue: Neutral As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: Connect the wire coloured green and yellow to the terminal marked either with the or colletter “E“ or by the earth symbol oured green and yellow. 2.
Environmental concerns Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic 12 appliances. Do not dispose appliances marked with the symbol with the household waste. Return the product to your local recycling facility or contact your municipal office. www.zanussi.
www.zanussi.
www.zanussi.
www.zanussi.
212000380-A-202013 www.zanussi.
