Owner`s manual

Additional Information
63
Note:
If the unit does not operate normally due to external effects such as static electricity,
disconnect the power plug from the outlet and insert again to return to normal operating
conditions.
Problem
No sound from surround or center
speakers.
Noise during playback of a cassette
deck.
Sound is produced from other
components, but not from LD or
DVD player.
No sound is output or a noise is
output when software with DTS is
played back.
When a search is performed by a
DTS compatible CD player during
playback, noise is output.
Cannot operate the remote control.
The display is dark or off.
Remedy
• Refer to “Speaker Setting” on page 35 to check the speaker
settings.
• Refer to “Setting the Relative Volume Level of Each Channel” on
page 39 to check the speaker levels.
• Connect the speakers properly (refer to pages 19–21).
Move the cassette deck further from your receiver, until the noise
disappears.
• Set the SIGNAL SELECT to AUTO, DIGITAL or ANALOG
according to the type of connections made. (refer to page 30).
• Set the digital input settings correctly (refer to page 38).
• Make digital connections (refer to page 14) and set the SIGNAL
SELECT
to DIGITAL (refer to page 30).
• Refer to the instruction manual supplied with the DVD player.
Set the digital volume level of the player to full, or to the neutral
position.
This is not a malfunction, but be sure to turn the volume down
to prevent the output of loud noise from your speakers.
• Replace the batteries (refer to page 7).
• Operate within 23 feet ( 7 m), 30° of the remote sensor on the
front panel (refer to page 7).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct
light.
Press FL DIMMER on the remote control repeatedly to return to
the default.