Owner`s manual

42
Using the Tuner
4 Press ENTER.
The preset class and number stop
blinking and the receiver stores the
station you want to listen.
Listening to Station
Presets
1 Press TUN (remote) or use the
MULTI JOG dial on the front panel
to select the tuner.
2 Press CLASS to select the class in
which the station is stored.
Press repeatedly to cycle through classes
A, B and C.
3 Press P-SET }/](PRESET
TUNING @/#) to select the
station preset you want.
Note:
If the receiver is left disconnected from the
AC power outlet for an extended period, the
station memories will be lost and will have
to be reprogrammed.
Naming Station Presets
For easier identification, you can name your
station presets.
1 Choose the station preset you want
to name.
See “Listening to Station Presets” above
for how to do this.
2 Press T EDIT/GUIDE (TUNER EDIT).
The display shows ST. NAME, then a
blinking cursor at the first character
position.
3 Input the name you want.
Names can be up to four characters long.
• Use the MULTI JOG dial (front panel)
or the P-SET }/] (remote) to select
characters.
• Press
ENTER to confirm a character. If
no character is input, a space is input.
• The name is stored when ENTER is
pressed after choosing the fourth
character.
Notes:
• To erase a station name, simply repeat
steps 1-3 and input four spaces instead of
a name.
• Once you have named a station preset,
you can press
DTV/DISP when listening
to a station to switch the display between
the name and the frequency.