Owner`s manual

12
5 Minute Guide
Using the Quick Setup
You can use the Quick Setup to get your
system up and running with just a few
button presses. The receiver automatically
makes the necessary settings after you have
selected your speaker setup and room size.
If you want to make more specific settings,
refer to “Choosing Your Receiver Setup” on
pages 34–39. Use the front panel controls
for the steps below.
DOWN UP
ENTER
MULTI JOG
VOLUME
MULTI JOG
R
SPEAKERS
S-VIDEO VIDEO L AUDIO R
ADVANCED
SURROUND
STEREO/
DIRECT
SIGNAL
SELECT
MIDNIGHT
MONITOR
TONE SETUP
L
ISTENING MODE
FL DIMMER
MULTI JOG
VIDEO INPUT
1 If the receiver is off, press POWER
to turn the power on.
The STANDBY indicator goes out.
2 Press SETUP.
The display prompts you to select your
speaker setup.
3 Use the MULTI JOG dial to choose
your speaker setup.
Cycle between the following choices:
5.1ch
3.0ch
4.1ch
5.0ch
3.1ch 4.0ch
Note:
Check the table below to find the speaker
setup that corresponds with your system.
Front
Speakers
√
√
√
√
√
√
3.0 ch
3.1 ch
4.0 ch
4.1 ch
5.0 ch
5.1 ch
Center
Speaker
√
√
×
×
√
√
Surround
Speakers
×
×
√
√
√
√
Sub
Woofer
×
√
×
√
×
√
4 Press ENTER.
The display prompts you to select your
room size.
5 Use the MULTI JOG dial to choose
your room size.
Depending on the distance of your
surround speakers from the listening
position, choose between Small,
Medium, or Large (see table below).
S
12 ft.
10 ft.
6 ft.
Front
Center
Surround
M
12 ft.
10 ft.
7 ft.
L
12 ft.
10 ft.
9 ft.
6 Press ENTER to confirm your
setup.
The display shows the speaker setup and
room size that you have selected.