User manual

34
7. Programme progress display
During programme development, the light
corresponding to the cycle phase which the machine
is in will illuminate. In other words, if the machine is
in the pre-wash or wash phases the light LAVADO
will come on; if it is in the rinses phase the light
will come on; if it is in the spin phase the light
will come on; and finally, if it is in the drain phase
the light will come on.
The light FIN will illuminate to indicate that the
selected programme has finished.
The light FIN flashes in the event of operating
problems:
• 4 flashes: door open.
• 2 flashes: problem with water draining.
• 1 flash: problem with water supply.
For more information see paragraph "Something not
working?" at the end of this booklet.
8. Spin speed selector dial
This dial allows the reduction of the final and the
intermediate spin speed or to select NO SPIN
option.
The speeds on the dials refer to cotton programmes.
In FA1025E model: position 1000 r.p.m.
corresponds to 900 r.p.m. for synthetics and 700 for
wool and delicates.
Position 500 r.p.m. is common for all fabrics.
In FA825E model: position 800 r.p.m. corresponds
to 800 r.p.m. for synthetics and 700 for wool and
delicates.
Position 400 r.p.m. is common for all fabrics.
• NO SPIN: by selecting this option all the
spinning phases are turned off. To be used for
extremely delicate items.
9. Programme selector dial
The selector dial can be turned either clockwise or
counter-clockwise.
Use this selector dial to select the required
programme.
At the end of each programme the selector dial
must be turned to position “
O”, to switch off the
machine.
ATTENTION!
If the programme selector dial is turned to another
position (programme) when the machine is working,
the lights of the programme progress display start to
flash. The machine will not perform the new selected
programme, but it will continue running on the same
cycle.
REMEMBER!
In the event a wrong programme has been selected
and the machine is already working, proceed as
follows:
1. Turn the programme selector dial to position “
O”.
2. Select the new required programme.
• If the machine has not already gone through the
rinse cycle, when you decide to change the running
programme, in the new programme the water and
the detergent from the previous cycle will be re-
used, making it an energy-saving tool. On the
other hand, if it is already in the rinse phase;
detergent, bleach,… must be re-measured.
3. Press INICIO / PAUSA button, to start the new
cycle.