s15 /Q( GAUSSIAN Instructions INSTRUCTION BOOK DEPT.
Contents Instructions for the owner Installation . Technical data . Use and care Using the oven . Analogue clock . General hints Upkeep and cleaning . Instructions for the installer Installation . . Electrical connection . ‘What happens if something goes wrong . Page Page Page o o e Page 10 Page 11 Page 13 Page 16 Page 17 Page 18 Caution Before you start operating the appliance, be sure to remove the plastic films protecting the stainless steel or anodized aluminum parts.
ructions for the owner : Installation It is mandatory that all operations required for the installation be carried out by QUALIFIED PERSONNEL in accordance with existing rules and regulations. The relevant instructions are to be found in the special chapter for the installer. ‘Warning ‘During normal cooking the oven heats up considerably at the level of the glass window of the door and other adjacent parts.
Technical data Dimensions: Height mm, $00 Depth mm. 538 Width mm. 597 Oven capacity cud. 54 Hob Rear left dia. mm. 145 (N) 1000 W Frost left dia. mm. 180 (R) 2000 W Rear right dfa. mm, 180 (N) 1500 W Front right dia. mm. 145 (N} 1000 W Maximum power absorbed 55 kW Oven Lower element 10 kW Upper element 10 kW Grill element 2.0 kW Oven lamp 15w Maximum power absorbed 2015 kW Power Supply (50 Hz) 240V Total power 7515 kW N = Normal electric cooking plate; R = Rapid electric cooking plate.
Use and care Hob with electric plates Control panel Bide grilles Grilles Oven door Removable drawer Front panel Removable base methodological-gey T Dripping pan, large J Reversible grill pan insert.
Control panel 1 General control light 2 Thermostat control light 3 Analogue clock 4 Oven selector knob 5 Oven thermostat knob 6 Rear left heat zone control knot 7 Front left heat zone control knob 8 Front right heat zone control knob 9 Rear right heat zone control knob
Operation Electric plates The control panel includes knobs for operating the four heating elements on the hob, The plates are controlled by a switch (Fig. 1) by means of a 6-position knob: 0 =0ff 1 = Minimum electric plate power 6 = Maximum electric plate power Increased power values are given by intermediate positions respectively.
U g the oven Preheat the oven, arrange the food in the oven, shut the door and turn the selector knob (Fig. 2) to symbol © ; turn then the thermostat knob (Fig. 3) to the required temperature. Heat, comes from the top and from the bottom, therefore it is preferable to use the central runner.
Using the grill Turn the oven selector knob (Fig. 2) to 8. Turn the oven grill regulator knob (Fig. 3} to the required temperature. As with the oven the grill control (see can be set to a number of different heat settings. At «max» position the maximum temperature is obtained.
General hints Use fat-hot tort pots and pans which have a diameter ar equal to that of the electric plates {Fig. 5). Flat-bottom pots enable energy saving and increase the service life of the electric plates. Follow instructions provided by the pots and pans manufacturer on their use. Save energy by using pots of the appropriate diameter, avoiding to select temperatures higher than those necessary and by exploiting the residual heat present on plates when they are turned off.
Hints for a correct use of the oven and the grill Whipped up kneading have the required firmness when they tend to stick to the spoon as, otherwise, an excessive fluidity would uselessly stretch the cooking time. Shortbread kneading should first be baked in the mold or in the baking-tin for about, two-thirds of the total baking time, and then be garnished {rimmed) before you complete the baking. This final baking time depends on the type and quantity of the armature (trimmings}.
Upkeep and cleaning For s long service life of the appliance, we strongly recommend that you frequently carry out a thorough cleaning operation. All operations must be carried out when the appliance has cooled. Important Before undertaking any cleaning or up keeping operation, be sure to have the appliance disconnected from the electric supply.
Aorta Fig. 10 Replacing appliance components Prior to undertaking any maintenance work or replacing the oven lamp or grill heating element, be sure fo disconnect the appliance farm the electric supply. 1. Control Knobs These can be removed by pulling them out. 2. Oven lamp replacement Unscrew glass cap (Fig. 9) and replace burnout bulb with one that resists to high temperatures (300°C), Electric bulb: 15W, 240V, 50Hz, 200°C. Bu.
Instructions for the installer Installation The following instructions are meant for 2 qualified installer and should ageist him in carrying out all installation, adjustment and maintenance operations in the most correct way and in accordance with existing laws and regulations. Important Before servicing the appliance or undertaking any maintenance work on it, be sure to disconnect it from the electric supply.
To remove the metal base rest the appliance on a side, slide out the front plastic panel (C Fig. 11) which is push fitted and then unscrew the six screws {D Fig. 11} that secure the base to the cabinet, Removing the leveling feet from the base (B Fig. screw them onto the cabinet and then fit the new front panel {optional) (B Fig. 12). Position the appliance.
The Manufacturer disclaims any Liability in case these accident-preventing rules are not observed. The heat insulation of the oven and grease residues from the manufacturing process produce smoke and an unpleasant smell during the first minutes of operation. 1t is therefore advisable, the first time the appliance is used, to per-heat the oven for about 30 mind.
—— ZANINESS APPLIANCE GUARANTEE GAUSSIAN STANDARD GUARANTEE CONDITIONS "This guarantee is in addition to your statutory and other legal rights which will nut be excluded or in any way diminished by the return of the guarantee card, We.