User manual

ManualsBrandsZanussi ManualsBattery ChargersDA4441

Clean the external surfaces of the machine and control panel

with a damp soft cloth. If necessary use only neutral

detergents. Never use abrasive products, scouring pads or

solvent (acetone, trichloroethylene etc....).

Ensure that the seals around the door, the detergent and rinse

aid dispensers are cleaned regularly with a damp cloth.

We recommend every 3 months to run a 65°C wash

programme without dishes using detergent.

Cleaning the central filters

(After each wash)

Inspect the central filters (B) and (C) and remove any scraps of

food with a brush, under running water.

Filters (B) and (C) are both removed by lifting up the outer one

(B) (pulling the central funnel upwards); the smaller filter (C)

can be removed by pressing the two tongues (D).

Once cleaned, refit the filters by pressing them down until they

click into place.

Cleaning the large filter

(Every week)

Clean the large filter (A) on both sides under running water,

using a brush.

To take it out, remove the

spray arm by pressing the

two tongues (E), turn the ring

(F) anticlockwise and then

slide the whole part out. Refit

the filter following the above

instructions in reverse order.

The dishwasher must not be used without filters.

Incorrect repositioning and fitting of the filters will

produce poor washing results.

Cleaning the filters is vital to ensure correct operation of

the machine.

To ensure a correct

working of the dishwasher,

NEVER try to remove the

upper spray arm.

If residues of soil have

clogged the holes in the

upper spray arm, remove

them with a toothpick.

Prolonged periods of non-operation

If you are not using the machine for any period of time you are

advised to:

1. Unplug the appliance and then turn off the water.

2. Fill the rinse aid dispenser.

3. Leave the door ajar to prevent the formation of any

unpleasant smells.

4. Leave the inside of the machine clean.

Frost precautions

Avoid placing the machine in a location where the temperature

is below 0°C. If this is unavoidable, empty the machine, close

the appliance door, disconnect the water inlet pipe and empty

it.

Moving the machine

If you have to move the machine (moving house etc....):

1. Unplug it.

2. Turn the water tap off.

3. Remove the water inlet and discharge hoses.

4. Pull the machine out together with the hoses.

Avoid over tilting the machine during transportation.

Maintenance and cleaning

MA33

MA02

MA08

MA03