DISHWASHER DA 6153 152968 28/1 Instruction Book UK
Description of the appliance 1. Upper basket stop 2. Water hardness switch 3. Salt container 4. Detergent dispenser (type A / type B) 5. Control panel 6. Rating plate 7. Rinse aid dispenser (type A / type B) 8. Filters 9. Lower spray arm 10. Upper spray arm 11. Upper basket 12.
In daily use ● Check if it’s necessary to refill with special salt or rinse aid Loading cutlery and dishes ● Load cutlery and dishes into the dishwasher. ● Fill with dishwasher detergent . Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher. ● Select a wash programme suitable for the cutlery and dishes. ● Start the wash programme. ● Before loading the dishes, you should: - Remove large left-overs.
The cutlery basket is in two parts which can be separated to give greater loading flexibility. To separate the two parts, slide them horizontally in opposite directions and pull them apart. To reassemble, reverse the procedure. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position.
Washing programmes Programme INTENSIVE 65°C Degree of soil and type of load Heavy soil Crockery, cutlery, pots and pans (1) ECONOMY Normal soil 50°C Crockery and cutlery Starting position of the programme selector dial Required main wash temperature push button A A ECONOMY 50° Cycle description (3) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) Cold prewash Main wash up to 65°C 2 cold rinses 1 hot rinse Drying 125 - 135 1,4 - 1,5
Operating sequence 1. Check that the baskets have been loaded correctly and that the spray arms can rotate freely Unloading the dishwasher Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. 2.
Fitting under a counter (kitchen worktop or sink) By removing the machine’s worktop, you can install it under a close fitting sink unit or a pre-existing top, providing the dimensions of the recess correspond to those shown in the picture. - 600 820 570 600 IN05 Proceed as follows: Remove the machine’s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the rear slots, lifting the worktop.
Service and Spare Parts In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Service Force Centre by telephoning: 08705 929929 Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.
Guarantee Conditions They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliance.
From the Electrolux Group. The world’s No.1 choice. The Electrolux Group is the world’s largest producer of powered appliances for kitchen, cleaning and outdoor use. More than 55 million Electrolux Group products (such as refrigerators, cookers, vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. 14 billion USD in more than 150 countries around the world.
Instruction book Dishwasher Before use Maintenance Installation
Contents Safety instructions 2 Disposal 3 Economical and ecological dishwashing 3 Prior to using for the first time The water softener Setting the water softener Filling with salt Rinse aid Use of detergent 3 3 3 3 4 5 Different kinds of detergent 6 Maintenance and cleaning Cleaning the filters Prolonged periods of non-operation Frost precautions Moving the machine 7 7 7 7 7 What to do, when...
Disposal Economical and ecological dishwashing Dispose of the dishwasher packaging material correctly. All packaging materials can be recycled. Plastic parts are marked with standard international abbreviations: >PE< for polyethylene, e.g. sheet wrapping material. >PS< for polystyrene, e.g. padding material (always CFCfree). >POM< for polyoxymethylene, e.g. plastic clips. Cardboard packaging is manufactured from recycled paper and should be deposited in the waste paper collection for recycling.
Filling with salt Rinse aid Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener. Only fill with salt just before starting one of the complete washing programmes.
Adjusting the dose Use of detergent According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (C) (position 1 minimum dosage, position 6 maximum dosage). Only use detergents specifically designed for use in dishwashers. Increase the dose if there are drops of water or lime spots on the dishes after washing. Using no more then the correct amount of detergent contributes to reducing pollution. The dose is factory set in position 5.
Different kinds of detergent Detergent tablets Use of "3 in 1" combi detergents Detergent tablets of different brands dissolve at different speeds. For this reason some detergent tablets cannot dissolve and develop their full cleaning power during short programmes. Therefore please use long programmes when using detergent tablets, to ensure the complete removal of detergent residuals. Do not place the tablets in the tub or in the cutlery basket as this will result in poorer wash results.
Maintenance and cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc....). 7. Put the flat filter (D) back in the base of the washing compartment. 8. Place the coarse/fine filter (A/B) in the microfilter and press together.
What to do, when... Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the instructions given here, without calling out an engineer. ...there are problems when operating the dishwasher The dishwasher will not start or stops during operation. All push buttons are inoperative except for the On/Off push button. Press the On/Off push button to switch the dishwasher off and carry out the following suggested corrective actions.
...the wash results are not satisfactory The dishes are not clean ● ● ● ● ● ● ● ● The wrong washing programme has been selected. The dishes were arranged in such a way as to stop water reaching all parts of the surface. The baskets must not be overloaded. The spray arms do not rotate freely due to wrong arrangement of the load. The filters in the base of the washing compartment are dirty or incorrectly positioned. Too little or no detergent has been used.
Installation instructions Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or competent person. Water outlet hose connection The end of the drain hose can be connected in the following ways: Remove all packaging before positioning the machine. 1. To the sink outlet spigot, securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine.
Electrical connection This appliance must be earthed. The manufacturer declines any responsibility should this safety measure not be observed. The appliance should not be connected to the electrical supply by means of an extension cable. If the plug that is fitted to your appliance is not suitable for the socket, it must be cut off and the appropriate plug fitted.
152971 08/2 Subject to change without notice 2 05/03
