User manual

14
Cleaning the hinged grill
This model has been fitted with a hinged grill element to
enable you to clean the roof of the oven easily.
Before proceeding ensure the oven is
isolated from the electricity supply.
1) Undo the screw which holds the grill in place
2) Then gently pull the grill downward to allow access to
the oven roof
3) Clean the oven roof with a suitable cleaner and wipe dry
before replacing the hinged grill element.
4) Gently push up the grill element into place and firmly
screw into place the holding nut.
NOTE: Ensure the grill holding nut is
firmly in place to avoid the grill falling
down during operation.
SYMPTOM
n The oven does not come on
n The oven temperature light does not come on
n The oven light does not come on
n It takes too long to finish the dishes, or they are
cooked too fast.
n Steam and condensation settle on the food and the
oven cavity.
n The timer does not work
n The oven fan is noisy
SOLUTION
u Check the oven is in manual operation and that both a
cooking function and temperature have been selected.
u Check the oven is wired in properly, and the socket
switch or the switch from the mains supply to the oven are
ON.
u Select a temperature with the thermostat control knob
u Select a function with the oven function control knob.
u Select a function with the oven function control knob
u Check the light bulb, and replace it if necessary (see
"Cleaning the Oven")
u The temperature may need adjusting
u Refer to the contents of this booklet, especially to the
chapter Using the Oven.
u Leave dishes inside the oven no longer than 15-20
minutes after the cooking is completed.
u Check the instructions for the timer.
u Check the grease filter is correctly fitted.
u Check that shelves and bakeware are not vibrating in
contact with the oven back panel.
If after all these checks, the oven still does not work,
contact your local Service Centre.
When calling for an engineer, please note you will be
asked to specify:
1) the type of fault;
2) the MODEL of the appliance;
3) the PROD.NO and the SER.NO of the appliance.
These data are given in the rating plate (see diagram).
If the oven is not working correctly, please carry out the following checks, before contacting your local Service Centre.
If something goes wrong
SER. NO.
Mod.
PROD. NO.
SER. NO.
MOD.
PROD. NO.
TYPE