User manual

17
The Oven Door
Before cleaning the oven door, we recommend you to
remove it from the oven.
Proceed as follows:
a) open the oven door completely;
b) find the hinges linking the door to the oven;
c) unlock and turn the small levers located on the
two hinges;
d) handle the door by its left- and right-hand sides,
then slowly turn it towards the oven until it is half-
closed;
e) gently pull the oven door off its site;
f) place it on a steady plan;
g) unscrew the two screws marked with lett. A;
h) pull up the oven door glass and take it away from
the oven door.
Clean the oven door glass with warm water and a softh
cloth only.
Once the cleaning is carried out, refit the oven door,
following the procedure in reverse.
For the BMS 841 X and BM 96 EX models, we
recommend to clean the outer surface of the oven door
with a wet sponge, and then carefully wipe it dry with a
soft cloth. Do not use any abrasive cleaning product,
such as steel wool or acids, as they could damage the
stainless steel surface.
Follow the same procedure for the control panel.
The Oven Door Gasket
The correct operation of the oven is ensured by a gasket
placed round the edge of the oven cavity.
 Periodically check the condition of this gasket. If
necessary, clean it without using abrasive cleaning
products.
 If the gasket shows to be damaged, call you local
Service Centre. Do not use the oven until it has been
repaired.
Oven Shelves and Shelf Supports
To clean the oven shelves, soak in warm soapy water and
remove stubborn marks with a well wetted soap
impregnated pad. Rinse well and dry with a soft cloth.
The shelf supports can be removed for easy cleaning (see
diagram). Please, ensure the retaining nuts are secure
when refitting the shelf support.
When cleaning the shelf supports, take care not
to remove the lubricating grease behind the
telescopic runners. This is meant to ensure their
good operation.
i