EN User manual Washing Machine ZWF 14069W 2
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Control panel _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 First use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Daily use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 6 Helpful hints and tips _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 8 Washing Programmes _ _ _ _ _ _ _ _ _ _ _ _ _ _ 10 What to do if… _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Technical data _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ Consumption values _ _ _ _ _
• Always be sure, that there is no water leakage from hoses and their connections after the installation. • If the appliance is installed in a location subject to frost, please read the “dangers of freezing” chapter. • Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. • Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.
Product description 1 2 3 4 5 6 Detergent dispenser drawer Control panel Door opening handle Rating plate Drain pump Adjustable feet 1 2 3 4 5 6 Detergent dispenser drawer Compartment for detergent used for prewash and soak phase or for stain remover used during the stain action phase (if available). The prewash and soak detergent is added at the beginning of the wash programme. The stain remover is added during the stain action phase. Compartment for powder or liquid detergent used for main wash.
1 1 2 3 4 Programme selector dial SPIN reduction button OPTIONS button EXTRA RINSE button 2 3 4 5 7 6 5 START/PAUSE button 6 DELAY START button 7 Indicator pilot lights Table of symbols Night Cycle Rinse Hold Programme selector dial, spin speed button and available options Available options: in times with a more economical power rate. On some programmes the rinses will be performed with more water. Before opening the door it will be necessary to empty out the water.
Super Quick Indicator pilot light (7) Short cycle for lightly soiled items or for laundry which needs only freshening up. We recommend you to reduce the fabrics loading. Extra Rinse This appliance is designed for saving energy. If it necessary to rinse the laundry using an extra quantity of water (extra rinse), select this option. Some additional rinses will be performed. This option is recommended for people who are allergic to detergents, and in areas where the water is very soft.
Pull out the dispenser drawer until it stops. Measure out the amount of detergent required, pour it into the main wash compartment or in the appropriate compartment if the selected programme/option it requires (see more details in "Detergent dispenser drawer"). If required, pour fabric softener into the compartment (the amount used must not exceed the marked «MAX» mark in the drawer). Close the drawer gently.
Altering an option or a running programme It is possible to change some options before the programme carries them out. Before you make any change, you must PAUSE the appliance by pressing the button 5 . Changing a running programme is possible only by resetting it. Turn the programme selector dial to Off and then to the new programme position. Start the new programme by pressing the button 5 again. The washing water in the tub will be not emptied out.
Rust: oxalic acid dissolved in hot water or a rust removing product used cold. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone1), lay the garment on a soft cloth and dab the stain.
Washing Programmes Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Detergent drawer COTTONS 90° - 60°1) Main wash - Rinses Maximum spin speed at 1400 rpm Max. load 5,5 kg - Reduced load 2,5 kg White cotton heavily or normally soiled items. SPIN NIGHT CYCLE RINSE HOLD PREWASH ECONOMY SUPER QUICK 2) EXTRA RINSE 3) COTTONS 60° - 30° Main wash - Rinses Maximum spin speed at 1400 rpm Max.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options HAND WASH 40° - Cold Main wash - Rinses Maximum spin speed at 900 rpm Max. load 2 kg Special programme for delicate fabrics with «hand washing» care symbol. SPIN NIGHT CYCLE RINSE HOLD EASY IRON 40° Main wash - Rinses Maximum spin speed at 900 rpm Max.
Programme - Maximum and Minimum Temperature - Cycle Description - Maximum Spin Speed - Maximum Fabrics Load - Type of Laundry Options Detergent drawer DELICATE SPIN Drain Maximum spin speed at 700 rpm Max. load 3 kg Separate spin for hand washed garments and after programmes with the Rinse Hold or Night Cycle option selected. You can reduce the spin speed to the required level by pressing the relevant button to adapt it to the fabrics to be spun.
Problem Possible cause/Solution The door has not been closed (the button 5 red light blinks). • Close the door firmly. The plug is not properly inserted in the power socket. • Insert the plug into the power socket. There is no power at the socket. • Please check your domestic electrical installation. The washing machine does not start: The main fuse has blown. • Replace the fuse. The programme selector dial is not correctly positioned and the button 5 has not been pressed.
Problem Possible cause/Solution There is water on the floor: Too much detergent or unsuitable detergent (creates too much foam) has been used. • Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings. It is not always easy to see this as the water runs down the hose; check to see if it is damp. • Check the water inlet hose connection. The drain or inlet hose is damaged. • Replace it with a new one.
Problem Possible cause/Solution Spinning starts late or the machine does not spin: The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in the drum, the machine will not spin.
Programme Energy consumption (KWh) Water consumption (litres) Programme duration (Minutes) 0.6 54 115 Synthetics 40° 0.5 50 80 Delicates 40° 0.55 50 65 Wool 30° 0.25 53 55 Cottons 40° 1) «Cottons + Economy» at 60°C with a load of 5,5 kg is the reference programme for the data entered in the energy label, in compliance with EEC 92/75 standards.
• the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. blocking the pump. Proceed as follows: • disconnect the appliance; • if necessary wait until the water has cooled down. Open the pump door. Place a container close to the pump to collect any spillage. Never remove the pump cover during a wash cycle, always wait until the appliance has finished the cycle, and is empty.
• Screw the hose back to the machine and make sure the connection is tight. • Turn on the water tap. Frost precaution If the machine is exposed to temperatures below 0°C, certain precautions should be taken. • Turn off the water tap. • Unscrew the inlet hose. • Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out. • Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again.
The inlet hose is screwed to the back of the appliance. Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance. Open the porthole and remove the polystyrene block fitted on the door seal. Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet. 35° Positioning Install the machine on a flat hard floor.
Firstly form a hook in the end of the drain hose using the “U” piece” supplied. 2. Onto a sink outlet spigot. Loop “U” piece supplied Place the drain hose into your standpipe, which should have an internal diameter of approximately 38 mm thus ensuring there is an air break between the drain hose and standpipe. When discharging into a standpipe ensure that the top of the standpipe is no more than 90 cm (35.4'') and no less than 60 cm (23.6'') above floor level. 38 mm (1.
1 2 3 4 1 SHOWER SINK TOILET BATH BIDET Green & Yellow Brown Cord clamp Blue 2 WASHING MACHINE DISHWASHER RAINWATER ‘RUN-OFF’ FOUL DRAIN SURFACE WATER DRAINS & SEWERS UNTREATED DISCHARGE RIVER FOUL SEWERS SEWAGE TREATMENT WORKS TREATED DISCHARGE RIVER Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Warning! THIS APPLIANCE MUST BE EARTHED.
contact your local council, your household waste disposal service or the shop where you purchased the product. Packaging materials The materials marked with the symbol are recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers.
www.zanussi.
