SPECIFICATION ZM360B-APS 9PA4601100 Main Feature: Low Noise High Efficiency Active PFC Circuit Full Range Input DEC 21, 2005 REV:01
MODEL: ZM360B-APS Revision History Rev Description Released 1.0 Date Author 2005/12/21 1. GENERAL DESCRIPTION AND SCOPE This is the specification of Model ZM360B-APS; AC-line powered switching power supply with active PFC (Power Factor Correction) circuit, meet EN61000-3-2 and with Full Range Input features. The specification below is intended to describe as detailedly as possible the functions and performance of the subject power supply.
Table. 1 Loading Table for Efficiency Measurements 360W(loading shown in Amps) Loading +12V1 +12V2 +5V +3.3V -12V +5Vsb Full 11.0 13.0 9.0 10.0 0.3 2.0 Typical 5.0 9.0 3.0 5.0 0.1 1.0 Light 3.0 3.5 1.0 2.0 0.0 1.0 Table 2. Minimum Efficiency Vs Load Loading Required Minimum Efficiency Required Minimum Efficiency Voltage Full load Typical load Light load 115V 75% 75% 70% 230V 80% 80% 75% 3.
.4.2. LOAD CAPACITY SPECIFICATIONS The cross regulation defined as follows, the voltage regulation limits DC include DC Output ripple & noise. LOAD STM. +3.3V +5V +12V1 DC +12V2 DC -12V +5VSB FULL LOAD MHMMHH 13.4A 21A 7.6A 7.6A 0.5A 2.5A FULL LOAD HMMMHH 22A 15.4A 7.6A 7.6A 0.5A 2.5A HLLLLL 22A 3A 3A 3A 0A 0A +3.3V MAX other MIN +5V MAX Other MIN +12V1&+12V2 MAX Other MIN -12V MAX other MIN +5VSB MAX other MIN LHLLLL 0.5A 15A 1.5A 1.5A 0A 0A LLHHLL 0.5 A 2.
4.6.OVER-CURRENT PROTECTION OUTPUT VOLTAGE +3.3V +5V +12V1 DC +12V2 DC Max. overcurrent limit 45.0A 45.0A 15.0A 20.0A 4.7.SHORT CIRCUIT PROTECTION Output short circuit is defined to be a short circuit load of less than 0.1 ohm. In the event of an output short circuit condition on +3.3V, +5V or +12V output, the power supply will shutdown and latch off without damage to the power supply.
5.0 FAN NOISE REQUIREMENTS 5.1.The subject power supply is cooled by a self-contained, 120mm, 12VDC fan. 1. FAN NOISE 2. ENVIRONMENTAL REQUIREMENTS AC INPUT 115V 230V FULL (Table.1) TYPICAL (Table.1) LIGHT (Table.1) NOISE≦30dB NOISE≦25dB NOISE≦22dB NOISE≦30dB NOISE≦25dB NOISE≦22dB The power supply will be compliant with each item in this specification for the following Environmental conditions. 6.1. TEMPERATURE RANGE 6.2. HUMIDITY 6.3.
6.5 RELIABILITY The power supply reliability,when calculated by MIL-HDBK-217;latest revision, are exceed 100,000 hours with all output at maximum load and an ambient temperature of 25℃. 6.6 DIELECTRIC STRENGTH Primary to Frame Ground : 1800 Vac for 1 sec. Primary to Secondary : 1800Vac for 1 sec 6.7 INSULATION RESISTANCE Primary to Frame Ground : 20 Meg.ohms Minimum Primary to Secondary : 20 Meg.ohms Minimum 7.0. LABELLING Label marking will be permanent, legible and complied with all agency requirements.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
