Installation Sheet

ManualsBrandsZ-Lite ManualsLightingSeoul 3 Light 12" Wide Outdoor Flush Mount Square Ceiling Fixture

INSTALLATION INSTRUCTIONS

Model 571F

Fig.1

Fig. 2

Fig. 3

FIXTURE

WIRES

Black or

Smooth

HOUSE

WIRES

Black

(Hot)

FIXTURE

WIRES

White or

Ribbed

HOUSE

WIRES

White

(Neutral)

FIXTURE

WIRES

Bare

Copper

(Ground)

HOUSE

WIRES

Green or

Bare

Copper

(Ground)

FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON

IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF. GENERAL

You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no

circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a

ceiling which contains a radiant type heating system. Read instructions carefully. If you are unclear as to how to

proceed, consult a qualified electrician.

NOTE: Proper wiring is essential for the safe operation of this fixture.

HANGING THE FIXTURE (Fig. 1)

1. Shut off the power at the circuit breaker and remove

the old fixture, including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the

parts on a clear area. Take care not to lose any small

parts necessary for installation.

3. Thread the 2 mounting screws (C) into the mounting

plate (B) spaced the same distance apart as the holes

in the fixture back plate. (You can adjust the length of

the screws if necessary.)

4. Attach the mounting plate (B) to the outlet box (A) (not

supplied) with mounting screws (D). GND must face

out.

CONNECTING THE WIRES (Fig. 2).

5. Connect the electrical wires as shown in Fig.2.Making

sure that all wire connectors are secured. If your

outlet box has a ground wire (green or bare copper),

connect the fixture’s ground wire to it. Otherwise,

connect the fixture’s ground wire directly to the

circular strap using the green screw provided.

COMPLETING THE INSTALLATION (Fig.1)

6. Align the fixture (E) to mounting plate (B) and secure

with cap nuts (F).

7. Install the bulb (E26 Medium base, not included) in

accordance with the fixture’s specification.

8.To prevent moisture from entering the outlet box and

causing a short, use clear caulking (i.e. Indoor/Outdoor

Silicone Sealant) to outline the outside of fixture back

plate where it meets the wall leaving a space at bottom

to allow moisture a means to escape. (Fig. 3)

DO NOT EXCEED THE MAXIMUM WATTAGE

RATING!

Your installation is now complete. Return power to the

junction box and test the fixture.

Caulking

Backplate

Summary of content (1 pages)

PAGE 1
INSTALLATION INSTRUCTIONS Model 571F FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF. GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully.