Installation Sheet

FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING

ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF.

GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the

order given. Under no circumstances should a fixture be hung on house electrical wires, nor

should a swag type fixture be installed on a ceiling which contains a radiant type heating system.

Read instructions carefully. If you are unclear as to how to proceed, consult a qualified electrician.

NOTE: Proper wiring is essential for the safe operation of this fixture.

ASSEMBLY INSTRUCTIONS

565CHB

CIRCULAR STRAP

CHAIN LOCK

UPPER COVER (2)

MIDDLE FRAME

SCREW (3)

GLASS CLIP (4)

GLASS (5)

SCREW (1)

FIXTURE LOOP

CHAIN

NIPPLE

CANOPY

LOOP AUT

HEX NUT

TOP LOOP

GROUND GREEN SCREW

MOUNTING SCREW

GROUND WIRE

WIRE CONNECTOR

POWER SUPPLY WIRE

OUTLET BOX

READ & SAVE

INSTALLATION & OPERATION INSTRUCTIONS

TOOLS & MATERIALS REQUIRED

Screwdriver Wire Cutters

Adjustable Wrench Wiring Supplies

CAUTION

Prior to assembly, refer to ELECTRICAL CONNECTIONS section. If you do not have electrical

wiring experience, refer to a do-it-yourself wiring handbook or have your fixture installed by a

qualified licensed electrician.

PAGE 1
FOR YOUR SAFETY WARNING: BE SURE THE ELECTRICITY TO THE WIRES YOU ARE WORKING ON IS SHUT OFF; EITHER THE FUSE IS REMOVED OR THE CIRCUIT BREAKER IS SHUT OFF. GENERAL You don’t need special tools to install this fixture. Be sure to follow the steps in the order given. Under no circumstances should a fixture be hung on house electrical wires, nor should a swag type fixture be installed on a ceiling which contains a radiant type heating system. Read instructions carefully.
PAGE 2
GENERAL 1. Be sure to read these instructions and review the diagrams thoroughly before beginning. 2. Electrical connections must be in accordance with local codes, ordinances, or the National Electric Code. If you are unfamiliar with methods of installing electrical wiring, secure the services of a qualified licensed electrician. 3. Before starting the installation, disconnect the power by turning off the circuit breaker or by removing appropriate fuse at fuse box.