Installation Sheet

Installation Instruction
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
"Note: The installation is for 3, 4,5 lites, the drawing shown below is for representative only,
not to match your new fixture."
1910-3,4,5, 1911-3,4,5
1. Carefully unpack your new fixture and lay out all the parts on clear area. Take care not to loose
any small parts necessary for installation.
2. Hold Back Plate up against the wall aligning the two holes in the Outlet Box with appropriate
slots in the Back Plate. Then while the Back Plate is leveled horizontally, use a pen or pencil
to make a mark on the wall at holes located near each end of Back Plate. Set aside the Back
Plate and insert Plastic Anchors into the two marks made on the wall.
3. Thread the supply wires and ground wire from Outlet Box through center holes in Back Plate.
4. Attached the Back Plate to Outlet box by using the two Outlet box Screws. If Plastic Anchors
were attached to the wall, secure the Back Plate with two Anchors Screws to corresponding
holes.
5. Connect the fixture wires to the Outlet Box wires as follows. Connect the White Fixture wire
to the White Supply Wire, Connect the Black Fixture Wire to the Black Supply Wire. Make
sure all wire Connectors are secure and do not easily pull off with the slight tug. If there is no
Green Ground Wire from the Outlet Box, Connect the Fixture Ground Wire to the Cross Bar
with the Green Grounding Screw provided.
6. Once all wires are connected, tuck them carefully into Outlet Box.
7. Place the Fixture Front Plate over the Mounting Screws, so it protrude through the hole in the
Back Plate.
8. Thread the Finial onto the Mounting Screws and continue turning until the Fixture Front Plate
is snug against Back Plate.
9. Slide Glass Shade and Socket Ring onto Socket, use Socket Wrench to secure Glass Shade and
Socket Ring. Install Bulb to Socket
10. Return the power to the Outlet Box and test fixture. Your installation is now complete.
Black Fixture
Wire
White Fixture
Wire
Outlet Box
Screw
Mounting
Screw
Back Plate
Anchor Screw
Plastic Anchor
White Supply
Wire
Supply Ground
Wire
Black Supply
Wire
Outlet Box
220V 25W
G9
Socket Ring
Fitter
Glass Shade
Bulb
Socket Wrench
Finial
Fixture Front
Plate

Summary of content (1 pages)