Installation Sheet

Installation Instruction
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
1. Carefully unpack your new fixture and lay out all the parts on clear area. Take care not to loose any
small parts necessary for installation. The model No. on the drawings are representative.
2. Thread the Threaded Nipple to the center hole of Cross Bar, secure the Cross Bar to the Outlet Box
by threading the two Outlet Box Screws.
3. Connect the fixture wires to the Outlet Box wires as follows. Connect the White Fixture wire to the
White Supply Wire, Connect the Black Fixture Wire to the Black Supply Wire. Make sure all wire
Connectors are secure and do not easily pull off with the slight tug. If there is no Green Ground Wire
from the Outlet Box, Connect the Fixture Ground Wire to the Cross Bar with the Green Grounding
Screw provided.
4. Once all wires are connected, tuck them carefully into Outlet Box. Then raise Wall Plate against wall
and tighten with Finial.
5. Secure Threaded Pipe to the bottom of Fitter, slide Plastic Washer, Metal Washer, and Plastic Washer
to the Threaded Pipe, put the Crystal Tube and Plastic Washer to the Threaded Pipe, tighten with Finial.
6. Slide Glass Shade onto Fitter, thread Bulb to Socket.
7. Return the power to the Outlet Box and test fixture. Your installation is now complete.
4161-1S 1908-1S
Bulb
Glass Shade
Finial
Washer
Outlet Box
White Supply Wire
Black Supply Wire
Hex Nut
Supply Ground Wire
Cross Bar
Threaded Nipple
Outlet Box Screw
Fixture Ground Wire
Black Fixture Wire
White Fixture
Wire
Threaded
Pipe
Finial
Plastic Washer
Crystal Tube
Plastic Washer
Metal Washer
Plastic Washer
Socket
Fitter
Wall Plate