Dimensions Guide

Installation Instruction
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
,1900/1901-1, 9019-1
1. Carefully unpack your new fixture and lay out all the parts on clear area. Take care not to loose any
small parts necessary for installation. The model No. on the drawings are representative.
2. Thread the Threaded Nipple to the center hole of Cross Bar, secure the Cross Bar to the Outlet Box
by threading the two Outlet Box Screws.
3. Connect the fixture wires to the Outlet Box wires as follows. Connect the White Fixture wire to the
White Supply Wire, Connect the Black Fixture Wire to the Black Supply Wire. Make sure all wire
Connectors are secure and do not easily pull off with the slight tug. If there is no Green Ground Wire
from the Outlet Box, Connect the Fixture Ground Wire to the Cross Bar with the Green Grounding
Screw provided.
4. Once all wires are connected, tuck them carefully into Outlet Box. Then raise Wall Plate against wall
and tighten with Finial.
5. Slide Glass Shade and Spacer onto Socket, and use Hand Tool to secure Glass shade and Socket Ring
and thread Bulb to Socket
6. Return the power to the Outlet Box and test fixture. Your installation is now complete.
White Fixture
Wire
Black Fixture Wire
Fixture Ground Wire
Outlet Box Screw
Threaded Nipple
Cross Bar
Supply Ground Wire
Hex Nut
Black Supply Wire
White Supply Wire
Outlet Box
Washer
Glass Shade
Socket
Fitter
Finial
Bulb
Socket Ring
Spacer
Hand Tool
Wall Plate