Preliminary User manual Z-COM XG-300 IEEE 802.11g WLAN Cardbus Card User Manual Version 0.
Preliminary User manual Table of Contents 0-INTRODUCTION ....................................................................................................3 1-CARDBUS INSTALLATION PROCEDURE.......................................................3 1.1 INSTALLING THE CARDBUS CARD INTO THE HOST PC NOTEBOOK ...................3 1.2 INSTALLING THE SOFTWARE DRIVERS ................................................................3 1.3 WIRELESS LAN INSTALLATION GUIDE LINES AND AUTHORIZATION FOR USE .
Preliminary User manual 0-Introduction The Z-Com XG-300 WLAN NIC is a complete wireless high speed Network Interface Card (NIC) utilizing the Intersil PRISM GT ® chip set. It conforms to the IEEE 802.11g protocol and operates in the 2.45 GHz ISM frequency bands. • Fully compliant with the IEEE 802.11g WLAN standards • FCC Certified Under Part 15 (pending) to Operate in the 2.45 Bands • Support for 54, 48, 36, 24, 18, 12, 9, and 6 Mbps OFDM, 11 and 5.
Preliminary User manual e-double click the Z-Com WLAN icon to open the WLAN settings, the following window will appear (see fig.02) fig, 02: Z-Com WLAN settings window f-click on configuration tab and select which type of network is required (access point or Peer-to-peer mode), see fig. 03.
Preliminary User manual g-select what TX rate is required (default setting is fully automatic) see fig. 04. fig, 04: WLAN tx rate setting window h-select what encryption type is required, 64 or 128 bit WEP (default setting is disabled) see fig. 05.
Preliminary User manual i-click on the status tab to see the connection status (fig.06). fig, 06: WLAN network status j-click on the about tab to see the software drivers versions and MAC address (fig.07).
Preliminary User manual 1.3 Wireless LAN installation guide lines and Authorization for use Installation and use of this Wireless LAN device must be in strict accordance with the instructions included in the user documentation provided with the product. Any changes or modifications made to this device that are not expressly approved by Z-Com may void the user’s authority to operate the equipment.
Preliminary User manual 2.4 FCC Radio Frequency Interference statement This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Preliminary User manual 2.6 Europe - EU Declaration of Conformity This device complies with the essential requirements and other relevant provisions of the European R&TTE Directive 1999/5/EC. Compliance to essential test suites is met per standards: R&TTE Harmonized Standard LVD specification EN 60950 ETSI EMC specification ETSI EN 301 489-1 V1.2.1 (2000-08) Description EN 60950,ed.
Preliminary User manual 3-Technical Specifications Radio Technology Operating Frequency Modulation Schemes RF Channel Availability Data Rate Media Access Protocol Transmitter RF Output Power Antenna Type Operating Voltage Interface Device driver Support FCC ID: M4Y-XG-300 IEEE 802.
