User's Manual
weuowue9p pPPPPro USER MANUAL
INTRODUCTION
The ST16 Pro is equipped with a touchscreen display that allows for changing
various sengs and viewing real-me telemetry data and streaming video during
flight. The ST16 Pro seamlessly integrates control of the camera so you can easily
take sll photos and start/stop video recording using the corresponding
buons.
OPERATING INSTRUCTIONS:
ST16 Pro AND RECEIVER BINDING
STEP 1): Power on the ST16 Pro and tap “RC” on the main interface
STEP 2): Tap Model Select and if required press “OK” to bypass any pop up warning/alerts.
STEP 3): Tap to create a new model and if required press “OK” to bypass any pop up warn-
ings/alerts.
STEP 4): Tap Flight Sengs and if required press “OK” to bypass any pop up warnings/alerts.
STEP 5): Li the H920 back end upward approximately 45° , then back down to “level” twice ll the
main LED indicator blinks yellow.
STEP 6): Tap the Refresh icon. Select the code of the H920 listed in the column under ”Model” and
tap Bind ,then tap “OK” aer the connecon has been established
STEP 7): When tapping, you will hear two long beeps from the aircraft. That means the ST16 Pro is
bound to the H920 successfully.
STEP 8): Tap [ ] twice to return to the main screen and the model /receiver should automacally
connect to ST16 Pro
NOTICE: The H920 main LED indicator will blink red and white if the TORNADO loses GPS signal
/lock. The H920 main LED indicator will be solid color of the current mode if the GPS signal/lock is
acquired.
ons, may cause harmful interference to radio communicaons. However, there is no guarantee
that interference will not occur in a parcular installaon. If this equipment does cause harmful
interference to radio or television recepon, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separaon between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
—Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE WARNING
• This equipment must be installed and operated in accordance with provided instrucons and the
antenna(s) used for this transmier must be installed to provide a separaon distance of at least 20
cm from all persons and must not be co-located or operang in conjuncon with any other antenna
or transmier. End-users and installers must be provide with antenna installaon instrucons and
transmier operang condions for sasfying RF exposure compliance.
IC RADIATION EXPOSURE STATEMENT FOR CANADA
This device complies with Industry Canada licence-exempt RSS standard(s).
Operaon is subject to the following two condions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired opera-
on of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitaon est autorisée aux deux condions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'ulisateur de l'appareil doit accepter tout brouillage radioélec-
trique subi, même si le brouillage est suscepble d'en compromere le fonconnement.
This equipment complies with IC RSS-102 radiaon exposure limit set forth for an uncontrolled
environment.
Cet équipement respecte les limites d'exposion aux rayonnements IC définies pour un environne-
ment non contrôlé