User's Manual

ST16 USER MANUAL
INTRODUCTION
The ST16 is equipped with a touchscreen display that allows for changing
various sengs and viewing real-me telemetry data and streaming video during
flight. The ST16 seamlessly integrates control of the camera so you can easily
take sll photos and start/stop video recording using the corresponding
buons.
OPERATING INSTRUCTIONS:
ST16 AND RECEIVER BINDING
STEP 1): Power on the ST16 and tap “RC” on the main interface
STEP 2): Tap Model Select and if required press “OK” to bypass any pop up warning/alerts.
STEP 3): Tap to create a new model and if required press “OK” to bypass any pop up warn-
ings/alerts.
STEP 4): Tap Flight Sengs and if required press “OK” to bypass any pop up warnings/alerts.
STEP 5): Li the H920 back end upward approximately 45° , then back down to “level” twice ll the
main LED indicator blinks yellow.
STEP 6): Tap the Refresh icon. Select the code of the H920 listed in the column under ”Model” and
tap Bind ,then tap “OK” aer the connecon has been established
STEP 7): When tapping, you will hear two long beeps from the aircra. That means the ST16 is
bound to the H920 successfully.
STEP 8): Tap [ ] twice to return to the main screen and the model /receiver should automacally
connect to ST16
NOTICE: The H920 main LED indicator will blink red and white if the TORNADO loses GPS signal
/lock. The H920 main LED indicator will be solid color of the current mode if the GPS signal/lock is
acquired.
ons, may cause harmful interference to radio communicaons. However, there is no guarantee
that interference will not occur in a parcular installaon. If this equipment does cause harmful
interference to radio or television recepon, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separaon between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
—Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE WARNING
• This equipment must be installed and operated in accordance with provided instrucons and the
antenna(s) used for this transmier must be installed to provide a separaon distance of at least 20
cm from all persons and must not be co-located or operang in conjuncon with any other antenna
or transmier. End-users and installers must be provide with antenna installaon instrucons and
transmier operang condions for sasfying RF exposure compliance.
IC RADIATION EXPOSURE STATEMENT FOR CANADA
This device complies with Industry Canada licence-exempt RSS standard(s).
Operaon is subject to the following two condions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired opera-
on of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitaon est autorisée aux deux condions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'ulisateur de l'appareil doit accepter tout brouillage radioélec-
trique subi, même si le brouillage est suscepble d'en compromere le fonconnement.
This equipment complies with IC RSS-102 radiaon exposure limit set forth for an uncontrolled
environment.
Cet équipement respecte les limites d'exposion aux rayonnements IC définies pour un environne-
ment non contrôlé