Yuneec™ SMARTRADIO™ ST10™ Quick Start Guide
Features IMPORTANT NOTE: This Quick Start Guide is NOT intended to replace the complete content included in the ST10 instruction manual. Although the following information covers some of the basic details you need to know we strongly recommend reading through the instruction manual completely before charging/using the ST10. Charging Your ST10 Use a suitable power source/supply (1.0A and 5V MAX output) and a cable with a Micro USB connector to charge the 3.6V Li-Ion battery installed in the ST10.
Using Your ST10 1.
• To create a new model tap the New Model button/icon • Give the new model a name, take or select an image (optional), select a type (if applicable) then Save the new model 4
• To edit or delet a model tap the model tap the model for about 2 seconds Flight Settings • Tap the Flight Settings button/icon • Tap the Bind button/icon 5
• Tap the Refresh button/icon, select the corresponding ID of the model and camera, then tap the Bind button/icon • Tap the Camera Select button/icon • Tap Select to select a camera 6
• Tap the Quick Review to review videos z Tap the Mode Select button/icon to change mode z Tap Hardware Monitor button/icon to know the status of channels 7
System Setting • Tap the System Settings button/icon FCC Statement: This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
IC Radiation Exposure Statement for Canada This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.