User Manual



SR12SUserManual
ConnectingSR12StoST24
Plugthecable from FC0(flightcontrolforHX4)intoSR12S socket,andpoweron HX4. LeanHX4
nose forward twice times,theBLUELED of SR12S willflashslowly, indicatingthe receiverready
forbinding.WhenthebindingbetweenSR12SandST24completes(seethefollowinginstructions
of Binding HX4 and ST24), the
 BLUELED will be off . Turn on ST24, press FPV and press ‘Take
off’.
Binding HX4 and ST24
 HX4withgimbal,cameraandLK58
Push the POWER Switch to the left side and Power on ST24→Keep HX4 nose to north, and
power on HX4 as the arrow shows →Wait until HX4 completes self-inspection, and BLUE LED
flashes→ Hold HX4 tail and lean the copter forward twice, and YELLOW LED flashes →Press
‘PAD’ →Press ‘Settings’ and find WiFi signal of LK58, choose it and enter the password, press
‘Connect’, it will show “Connected”→Press
twice and back to the main interface →Press
‘FPV’ on the main screen of ST24 →Press ‘System Settings’ →Press ‘Refresh’ →Choose your
Model and Camera →Press ‘Bind’ →Press
→Press ‘Take Off’ and you will hear 2 beeps,
 Lackanyoneofgimbal,cameraorLK58
Push the POWER Switch to the left side and Power on ST24→Keep HX4 nose to north, and
power on HX4 as the arrow shows →Wait until HX4 completes self-inspection, and BLUE LED
flashes→ Hold HX4 tail and lean the copter forward twice, and YELLOW LED flashes →Press
RC → Press ‘system settings’ →Press ‘Refresh’ →Choose your receiver’s code of HX4→Press
‘Bind’ →Press
→Press ‘Ready’ and you will hear 2 beeps 
