User's Manual

ManualsBrandsYuneec Technology ManualsElectronicsSR12E

SR12EUserManual

ConnectingSR12EtoST24



Plugthecable fromFC0(flightcontrolfor HX4) intoSR12E socket, and poweron HX4. Lean HX4

noseforwardtwicetimes,theBLUELED ofSR12E will flashslowly,indicatingthereceiverready

forbinding.WhenthebindingbetweenSR12EandST24completes(seethefollowinginstructions

of Binding HX4 and ST24),

 the BLUELEDwill be off. Turn on ST24, press FPV and press ‘Take

off’.

Binding HX4 and ST24

z HX4withgimbal,cameraandLK58

Push the POWER Switch to the left side and Power on ST24→Keep HX4 nose to north, and

power on HX4 as the arrow shows →Wait until HX4 completes self-inspection, and BLUE LED

flashes→ Hold HX4 tail and lean the copter forward twice, and YELLOW LED flashes →Press

‘PAD’ →Press ‘Settings’ and find WiFi signal of LK58, choose it and enter the password, press

‘Connect’, it will show “Connected”→Press

twice and back to the main interface →Press

‘FPV’ on the main screen of ST24 →Press ‘System Settings’ →Press ‘Refresh’ →Choose your

Model and Camera →Press ‘Bind’ →Press

→Press ‘Take Off’ and you will hear 2 beeps,

z Lackanyoneofgimbal,camer aorLK58

Push the POWER Switch to the left side and Power on ST24→Keep HX4 nose to north, and

power on HX4 as the arrow shows →Wait until HX4 completes self-inspection, and BLUE LED

Summary of content (4 pages)

PAGE 1
SR12E User Manual Connecting SR12E to ST24 Plug the cable from FC0(flight control for HX4) into SR12E socket, and power on HX4. Lean HX4 nose forward twice times, the BLUE LED of SR12E will flash slowly, indicating the receiver ready for binding. When the binding between SR12E and ST24 completes (see the following instructions of Binding HX4 and ST24), the BLUE LED will be off. Turn on ST24, press FPV and press ‘Take off’.
PAGE 2
flashes→ Hold HX4 tail and lean the copter forward twice, and YELLOW LED flashes →Press RC → Press ‘system settings’ →Press ‘Refresh’ →Choose your receiver’s code of HX4→Press ‘Bind’ →Press →Press ‘Ready’ and you will hear 2 beeps Socket for FC0 Socket for gimbal Antenna SR12E BLUE LED Status Three status for SR12E BLUE LED: off, slow flash, and solid. ‐Slow flash of the BLUE LED indicating the receiver is ready to bind. ‐Solid BLUE LED indicates smooth working status of SR12E.
PAGE 3
FCC Statement: This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
RF exposure warning · This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance.