User's Manual

4. POWERING ON
Step 1) Plug the audio connector into audio port of the
MK58; then plug the 4PIN power connector into power
output port of GB203.
IMPORTANT NOTE：In this User Manual, the TYPHOON
is taken as an example. If you have any other compable
power supply equipment or wearable equipment, you can
plug the 4PIN power connector of the MK58 into power
output port of other equipment as well.
STEP 1. Plug the MINI USB connector into USB
interface of GoPro Camera
STEP 2 . Switch on the GoPro Camera. Power on the MK58.
IMPORTANT NOTE：In this User Manual, the
TYPHOON is taken as an example. If you have any
other compable power supply equipment or
wearable equipment, you can plug the 4PIN power
connector of the MK58 into power output port of other
equipment as well.
STEP 3. Bind the MK58 to the Personal Ground
Staon/Remote Controller: Switch on the Personal
USING YOUR MK58
Model: Typhoon
Welcome,Pilot 10:48:28 pm
10
Bind
Camera Select
Hardware Monitor
Mode Select
STEP8. Input password "12345678" and then tap
"OK". The binding succeeds.
STEP 9. Aer the Ground Staon/ Controller and the
MK58 are bound, the red LED of the MK58 will blink.
Press to return to the main interface of the Ground
Staon/Controller. The real-me images can be shown
on the interface of the Ground Staon/ Controller.
IMPORTANT NOTE: All safety precauons and warnings,
instrucons, warranes and other collateral informaon is subject to
change at the sole discreon of Yuneec. For the most up-to-date
informaon please visit the corresponding product page at
www.Yuneec.com or contact the nearest Yuneec office or authorized
distributor.
The following special language terms are used throughout the
product literature to indicate various levels of potenal harm when
operang this product:
NOTICE: Procedures, which if not properly followed, create a
possibility of property damage and/or lile to no possibility of injury.
CAUTION: Procedures, which if not properly followed, create the
probability of property damage and/or a possibility of serious
injury.
WARNING: Procedures, which if not properly followed, create the
probability of property damage, collateral damage and/or serious
injury or create a high probability of superficial injury.
WARNING: Read the ENTIRE instrucon manual to become
familiar with the features of the product before operang. Failure
to operate the product correctly can result in damage to the
product, property and/or cause serious injury.
WARNING: This is a sophiscated consumer product. It must be
operated with cauon and common sense, and requires some basic
mechanical ability. Failure to operate this product in a safe and
responsible manner could result in damage to the product,
property and/or cause serious injury. This product is not intended
for use by children without direct adult supervision. Do not use
with incompable components or alter this product in any way
outside of the instrucons provided by Yuneec. The instrucon
manual contain instrucons for safety, operaon and maintenance.
NOTICES AND WARNINGS
FCC STATEMENT:
This equipment has been tested and found to comply with the limits
for Part 15 of the FCC rules. These limits are designed to provide
reasonable protecon against harmful interference in a residenal
installaon. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instrucons, may cause harmful interference to radio
communicaons.
However, there is no guarantee that interference will not occur in a
parcular installaon. If this equipment does cause harmful
interference to radio or television recepon, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
1. INTRODUCTION
The MK58 is a professional digital video downlink
module, especially designed for GoPro Camera
Without any other extra module, real-me images can
be directly transferred to the Ground Staon/
Controller with almost no delay. The MK58 is portable
in size and allows for easy installaon.
6. CONTROLLING THE MK58
2. SPECIFICATIONS
Dimensions (without antenna):
2.48 X 1.19 X 0.45 in (63 X 30.2 X 11.5 mm)
Weight (With antenna, connector): 36 g (1.27 oz)
Compable Camera :
GoPro Hero 3, Hero 3+, Hero 4 Black Hero 4 Silver
Working Voltage: 5V（+/-0.5V）
Working Current: 1A
Video Transmission Range: 400m
3. LED STATUS:
Upon Powering On: Blue LED solid.
Aer Powering On: Red LED solid.
Aer binding to Personal Ground Staon/
Remote Controller: Red LED blinking.
Controlling the MK58 by Personal Ground Staon/
Remote Controller
NOTICE: The inappropriate pasng posion may cause
electronic interference or poor venlaon.
It is essenal to read and follow all the instrucons and warnings prior
to assembly, setup and/or use in order to operate the product
correctly and avoid damage or serious injury.
Age recommendaon: not for children under 14 years. This is not a toy.
GENERAL SAFETY PRECAUTIONS AND WARNINGS
WARNING: Failure to use this product in the intended manner as
described in instrucon manual can result in damage to the product,
property and/or cause serious injury. This product is not a toy! If
misused it can cause serious bodily harm and damage to property.
WARNING: As the user of this product you are solely and wholly
responsible for operang it in a manner that does not endanger yourself
and others or result in damage to the product or the property of others.
Do not aempt to operate your equipment in areas with potenal
magnec and/or radio interference including areas nearby broadcast
towers, power transmission staons, high voltage power lines, etc.
Reorient or relocate the receiving antenna.
Increase the separaon between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.
This device complies with part 15 of the FCC rules. Operaon is
subject to the following two condions:
(1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operaon.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protecon against harmful interference in a residenal installaon.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instrucons, may cause harmful interference to radio communica-
ons. However, there is no guarantee that interference will not
occur in a parcular installaon. If this equipment does cause
harmful interference to radio or television recepon, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separaon between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF EXPOSURE WARNING
This equipment must be installed and operated in accordance with
provided instrucons and the antenna(s) used for this transmier
must be installed to provide a separaon distance of at least 20 cm
from all persons and must not be co-located or operang in
conjuncon with any other antenna or transmier. End-users and
installers must be provide with antenna installaon instrucons
Ground Staon/Remote Controller and tap "Flight Seng".
STEP 4. Select "Camera Select".
USER MANUAL
STEP 1. Plug the antenna in
the antenna port.
NOTICE: When plugging the antenna in and out
of the antenna port, it should be in vercal posion
(see illustraon above).
STEP 2. Plug the power
cord in the audio port.
STEP 3. Remove the adhesive tape
on the MK58.
Do not bend the antenna!
The text described in the User Manual takes TYPHOON
Q500 series, GB203 and ST10+ from YUNEEC as example.
You should read the User Manual completely before
proceeding.
Do not operate the MK58 in the rain!
Do not expose the MK58 to fire sources!
WARNING !
Do not expose the MK58 to excessive heat or sun
light!
Do not fly in winds that exceed 17MPH (28KPH)!
MINI USB
MINI USB
MK58 Body
Power Cord
Mushroon
Antenna
4PIN
T-F Card Port
Audio
Connector
4PIN
AUDIO
STEP 4. Paste the MK58
within the red marked area.
STEP 5. Select "GoPro", tap "Select" and then tap "OK".
Then the Camera Mode is chosen.
STEP 6. Back to the previous interface and tap “Bind”.
STEP 7. Select the MK58 in "Camera" interface .
Step 2) Switch on the aircra and the MK58 will be
supplied with power. Then the blue LED of the MK58 is
on.
NOTICE: Aer about 30 seconds, the red LED of the
MK58 is on, which indicates the MK58 is ready to work.
5. POWERING OFF
Switch off the aircra and the MK58 powers off. The
blue and red LED of the MK58 will be off.
Model: Typhoon Welcome,Pilot 10:48:28 pm
10
GPS
Ready
SAT
13
POS
00.0000E
00.0000N
MODE
Angle
ALT
21.4 
VOLTS
12.3 V
G-SPD
0.0 mph
DIS
22.5 
System Sengs Flight Sengs
Model Select
HOME
20/08 MK58 USER MANUAL
Any informaon above might be changed due to
the soware update. For the latest documents,
please check the official website.
and transmier operang condions for sasfying RF exposure
compliance.
IC RADIATION EXPOSURE STATEMENT FOR CANADA
This device complies with Industry Canada licence-exempt RSS
standard(s).
Operaon is subject to the following two condions: (1) this
device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired
operaon of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada
applicables aux appareils radio exempts de licence. L'exploitaon
est autorisée aux deux condions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'ulisateur de l'appareil doit
accepter tout brouillage radioélectrique subi, même si le brouillage
est suscepble d'en compromere le fonconnement.
This equipment complies with IC RSS-102 radiaon exposure limit
set forth for an uncontrolled environment.
Cet équipement respecte les limites d'exposion aux rayonnements IC
définies pour un environnement non contrôlé
This radio transmier (11554B-MK58) has been approved by Industry
Canada to operate with the antenna types listed below with the
maximum permissible gain indicated. Antenna types not included in this
list, having a gain greater than the maximum gain indicated for that type,
are strictly prohibited for use with this device.
Le présent émeeur radio (11554B-MK58) a été approuvé par Industrie
Canada pour fonconner avec les types d'antenne énumérés ci-dessous
et ayant un gain admissible maximal. Les types d'antenne non inclus dans
cee liste, et dont le gain est supérieur au gain maximal indiqué, sont
strictement interdits pour l'exploitaon de l'émeeur.