User's Manual

User’s Manual for 553190

** GENERAL PRODUCT INFORMATION **

⚫ Egg Material: Liquid Silicone

⚫ Remote Material: ABS with metal plating + ABS with PU coating

⚫ Vibration Function: 10 modes (3 speeds + 7 patterns)

⚫ DC (pin) Rechargeable (both egg and remote)

** IMPORTANT NOTICE FOR INITIAL USE **

⚫ Make sure the product is 100% dry before charging.

⚫ Before first use, the vibrator needs to be charged between 4-6 hours using the designated DC charging

cable (included).

⚫ Normal Charging Time after the first use: 2 ~3 hours

⚫ Indicator light on power button blinks: indicates that device is charging

⚫ Indicator light steadily on: indicates that device is fully charged

⚫ The Vibrator will run for 60 minutes on highest speed

**OPERATING INSTRUCTIONS**

a. Operating the EGG through its own buttons

⚫ To turn on toy & start the Vibration Function:

• Enter StandBy Mode: Press and hold button at the end of the egg’s string for 2 seconds, vibration

function does not start working automatically, indicator light is on. You’re now on StandBy mode.

• Short press the same button to start vibration function at speed 1, keep pressing to cycle between 3

speeds + 7 patterns.

• Press and hold the same button for 2 seconds to turn device off, LED light is also off.

Liquid Silicone Body

ABS with PU coating

ABS with metal plating

PAGE 1
User’s Manual for 553190 ABS with metal plating Liquid Silicone Body ABS with PU coating ** GENERAL PRODUCT INFORMATION ** ⚫ Egg Material: Liquid Silicone ⚫ Remote Material: ABS with metal plating + ABS with PU coating ⚫ Vibration Function: 10 modes (3 speeds + 7 patterns) ⚫ DC (pin) Rechargeable (both egg and remote) ** IMPORTANT NOTICE FOR INITIAL USE ** ⚫ Make sure the product is 100% dry before charging.
PAGE 2
b. Operating the EGG through PAIR MODE (egg and remote work as a pair) ⚫ To turn on toy & enter pair mode: First, press and hold button at the end of the egg’s string for 2 seconds, indicator light on the egg is on. You’re now on StandBy mode. Then press and hold the power button on the remote for 1.5 seconds, PAIR MODE is activated, but vibration function does not automatically start.
PAGE 3
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.