Doc. No.
Doc. No.: WFC001-A05 The photograph installed in end-products is actually appended. The VN210 is mounted by soldering the red circle part in the figure below.
Doc. No.: WFC001-A05 Antenna Connection: Connection from VN210 output to the antenna input. Connection shall be made by professional personnel only. Case 1 is connected directly from VN210 to antenna by cable. Case 2 is connected from VN210 to the antenna via a short stub and the cable.
Doc. No.: WFC001-A05 CASE 2 The signal output from the VN210 module is connected with the antenna via the short stub that exists on the IF board.
Doc. No.: WFC001-A05 VN210 is installed in EJX, YTA, and YFGW710 and the following note sentence is described in the user manual. FCC and IC Regulations ・This device complies with Part 15 of the FCC Rules and RSS-Gen of IC Rules. Operation is subject to the following two conditions :(1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation.