RV Door Lock Operation Instructions @ lle L Replace your common handle with a new RV Door Key less Handle Lock The opening for your common handle will measure approximately 3.75 inches tall x 2.75 inches wide x 1.5 inches deep 3.75 INCHES 2.
RV Door Lock Installation Instructions Remove the Existing Handle 1. Securely latch your RV door in the open position. 2. Remove the 4 screws from the back of the existing handle{see Fiz 1). 3. Remove the 2 screws and the strike plate from the side of the door {Fig.2} you will now be able to remove the front portion of the handle [~1z 4). At this point you are ready to install and program your new RV Door key less Handle Lock. Installing the new Key less Handle 1.
RV Door Lock Installation Instructions Then, hold the front handle in place so that it does not fall and attach the new strike plate Fig with the 2 shorter screws on the door jamb side (Fig.6). 4. While holding the RV Door Lock’ s Back Handle , connect the battery wires to the Front Handle that is already in the door (Fiz. 7).A confirmation beep signifies that the connection is made. NOTE: “ON/OFF” switch does NOT have to be in the ON position {This switch only turns on the ability to use the FOB/remote).
RV Door Lock Operation Instructions Program Your Fob/Remote 1. Turn the switch to “ON” at the back of your handle (Fig 10). Then press the “FOB Learn” button located just above the ON/OFF switch on the back of the handle (Fiz 11). Short, quick beep will confirm that you entered the programming mode. 2. Now press the LOCK button on your REMOTE (Fig 12) until the handle confirms a sync with a long beep (may take 2 {0 3 clicks). 3.
RV Door Lock Operation Instructions Program Your Keypad Numeric Keypad Footlights lta 8 1. Write down your desired “new” code below. {we recommend 4 to 8 digits) 2. While holding down the “8” button,simultaneously press the “LOCK” button then release both.A long confirmation beep signifies that you have entered the programming mode. 3. Type in the existing code (default code is; “1234”) and then press the “LOCK” button. 4. New type in the new code, then press the “LOCK” button. 5.
RV Door Lock Battery Use and Replacement Program Your Fob/Remote Fig.13 Remove the 2 screws holding the battery cover on the back of the Handle (Fig 13) and install 4 AA alkaline batteries (Fig 14). A beep will confirm that the handle has power, MOTE: » When replacing the batteries,install hi-quality and fully charged alkaline batteries. «When you swipe your IC Card or use the remote control, there _ will be three long beeps means the batteries are low. Fig.
RV Door Lock Operation Instructions Program Your Fingerprint Recognition 1. Press the “FOB Learn” button located just above the ON/OFF switch on the back of the handle (Fig 10). 2.While pressing the "FOB learn” button, place your finger on the fingerprint sensor {Fig 11). When the fingerprint sensor starts flashing blue light, release the FOB learn button. 3.
RV Door Lock Accessories Included DOOR LOCK 4-IN-1 SCREW DRIVER i.
RV Door Lock NOTE Note: This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.