12 Terms and Conditions Please read these instructions carefully before using this product. The instructions contain Important information which wilt help you get the best out of the product and ensure safe and proper installation, use and maintenance. Do Rot squeeze or impact the product forcibly. + Do ot disassemble or madly this product « Children shooed be supervised to ensure that they do not use this product as toy to avid unnecessary accidents.
« Before use, please clean the ovenproof and the bettor ensuring that the area Is free of dust and water. an using. please install: the oof rack on & ist and smiths part on the roo, The surface where the suction foots are placed must not have cracks, Bo nat install the roof rack in places where there vinyl stickers or where the are joins between panels, glass of plash.
Introduction Learn about your new FORENOON bike rack FORENOON Electric Inverted Sucker Roof Rack Handel bar strap Saddle strap Saddle holder Suction foot Handel bar clamp N-Power Control box .
Introduction Alarm System Instructions 1 Your bike rack s fitted with a safety alarm which will alert you If the bac loses ts connection with the vehicle The alarm will sound fa suction foot leaks In the even of this happening the N-Power system will automatically attempt to create a vacuum sel using the built In pump. 2. The alarm modules fitted with a resistance USB which can be connected to your vehicle ether vi the vehicles own USE, a USB adapter or USB port on a sound system.
16 Introduction installation of your Forenoon rack Hose Connection Remove the dust seal plug } spineless nameplate sss Hose Disconnection Jor more ess ‘the locking interface I = "b.
Instructions Installation method 1 1. Pla alarm in the vehicle connect the lammed to a suitable USB power supply. [forking normally a red LED light will be shown. 2.install the handlebar suction foot and saddle suction goat on she bicycle as shown in Figure |, and tie the straps tightly, with he bottom surface of al suction foots facing upwards frontally. Connect the hose on one of the handlebar suction foot the either ran disbar suction foot. 3.
26 Instructions Installation method 2 1. Place the alarm In the vehicle Connect the alarm te a suitable USB power supply, f working normally 2 red LED light wit be shown. 2, Select the installation position of each suction foot on the of or back of the vehicle according ta Figure Hl 3, Put the control box suction foot in the selected position, tur 0 the power switch,and press the control box down,so that the suasion aot is fully adsorbed on the interstellar surface.
Instructions 5. Tithe saddle suction foot u the bicycle saddle, an tie the strap tightly to avoid shaking and Loosening ruing driving, 6.
Trouble Shooting Problem Possible issue Solution Please check Lib connection Check the USB connection, Alarm isn't functioning and power sort. mm is damaged, Contact customer service, Low power in battery, Fut charge and retry. Control bax isn't functioning Battery is damaged. Can tact customer device. Central bo lights not Loose connection. Check wires are connected proper. functioning when charging System sin steep mode. seas Norma. Not the above and still not working, Contact customer service.
Warranty ‘The after sales service of this FOREKNOWN Electric inverted Sucker Roof Rack controller fs strictly bases nth be “Consumer Rights Protection of he People's Republic ofChing® ang “The Product Low of he People’s Republic of China” , Warranty period 1th product falls to perform within 7 days of purchase, it soul se nested by the manufacturers sitar sales service pence to determine If there 53 foul. 2.
p23 Maintenance ‘The pneumatic ar hoses and interlocking interfaces should be costed with a silicone bases o: to ensure sealing performance fa suitable lubricant cannot be fandango edible oil. can be used as a substitute. When the roof rack is ot Tn use please disconnect prismatic air hoses and replace the dust sea plug to prevent dict or debris from entering the system, After use please ensure the battery in the control boxes fully charged and check the battery level every 3 months.
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user” s authority to operate the equipment. This equipment has been. tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the BCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.