User's Manual

User manual
Projector connection
Projection distance and size
Specification
Display technology light source native resolution Resolution support
Projection distance Projection size focus Aspect ratio
speaker Electronic Keystone unit size installation type
Front Projection/Rear
Projection/Ceiling Mount
port Supported
Audio Formats
manual
Notice
video
Movie
Use correctly
Wrong usage
Troubleshooting Guide
1. The picture is not clear
*Adjust the focus ring.
*Projector and screen/wall must be at a valid distance.
⒉ Remote control no response
*Ensure the remote point directly on the IR receiver.
*Do not block IR reception.
*Check the battery.
3. Mobile connection
Mobile phone: use the same screen device
Computer: HDMI connection of ordinary computer / Apple
computer or type-c to HDMI cable without HDMI output
(for computer, please switch to copy or expand mode)
4. Upside down image
Enter the "Menu" on the projector or remote to flip the
projected image
packing list
Model: YD10
Remote control
Instructions
Function description
Arrow keys
oK-confirmed
focusing
Audio input
TF card V
entilation and heat dissipation
Fastest to use
Insert the power cord into the socket and
then into the machine
Connect the device to the projector correctly
Press the power button to turn on the projector
Select the correct type of program to play
Adjust the focus knob for best performance
Enter link
Signal source
HDMI link
Signal source
Signal source
User manual
OK
OK
power supply
signal source
superior
Left
volume-
home page
voice control
live streaming
return key
V
olume+
Down
right
Individual shopping
projector
projector
Lens
HD
Power
interface
projector
FCC Warning
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE 1: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
To comply with FCC RF exposure compliance requirements, this grant is applicable to only mobile configurations.
The antennas used for this transmitter must be installed to provide a separation distance of at least 20cm from all
persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
Changes or modifications not explicitly approved by the party responsible for
compliance could void the user's authority to operate this equipment.