USB Adapter Manual

2017/1

YGE PC- & Update Tool for Windows

We point out that the mode-setup has to be successfully done before programming

any parameters with the PC-tool. Please take a look at the manual of your ESC.

 USB- cable is to be connected to the YGE-USB-Adapter and plugged into any PC

USB slot.

 Wait until Windows has installed the appropriate driver. It can take up to 2 minutes.

Basis for this is an Internet connection. It is possible that some Windows versions

ask you if Windows-Update should look for the latest driver. Confirm this message

with "Yes" and wait until the driver has been downloaded.

 Carry out YGE Config.exe or FwUpadte Gui.exe.

 Tab above "Config" - Choose Connection. A small window opens. Under "Selection

Interface" click the button "Check" once.

 Now you should find the correct COM- interface with the cursor on the left side of the

list (for ex COM3). You can now select it by clicking on it; it will now be transferred

above under "Interface name".

In case no COM-interface will be found automatically, you can enter it manually yourself under

"Interface name". Check the Windows advice- manager under connections (COM & LPT) for

"USB Serial Port". For ex, COM3 should appear in brackets.

 Close the communication-window.

 Connect the USB-Adapter to the controller. (look at the back page)

 Connect the main battery to the controller and wait until the yellow and red LED are

Connect flashing permanently.

 Click on "Connect". The connection will be built up and the controller will be read out.

 Go to "File save" and save the newly generated ycf.file in any folder, so that the state

of delivery might be re-transferred at a later date. Now you can change the

parameters and transfer the data to the controller with "Write".

 With the FwUpdateGui you can carry out a firmware-Update once you have received

the corresponding software from us. Tick the field "Save ycf" in front of the "Regler-

Connect" , then your previous parameters will be saved.

 Once you are done with programming or an Update, disconnect the main battery and

then disconnect the USB-cable.

PAGE 1
YGE PC- & Update Tool for Windows We point out that the mode-setup has to be successfully done before programming any parameters with the PC-tool. Please take a look at the manual of your ESC.  USB- cable is to be connected to the YGE-USB-Adapter and plugged into any PC USB slot.  Wait until Windows has installed the appropriate driver. It can take up to 2 minutes. Basis for this is an Internet connection.
PAGE 2
YGE 20LVT, 35LVT & 65LVT: The telemetry-cable of your ESC (blue plug) has to be connected to the 3-pin connector in the middle of the USB-adapter. YGE 90HVT & 120HVT: The attached 5-pin JST-cable has to be connected to the 5-pin-port of your ESC and the other side to the 5-pinport of the USB-adapter. YGE 160HVT & 200HVT: The attached three-core cable has to be connected to the 10-pin-port of your ESC and the other side to the 3pin connector in the middle of the USB-adapter.