Collaboration Touch Panel CTP18 English | 简体中文 Quick Start Guide (V1.0) www.yealink.
CTP18 Connection Connect your CTP18 Video Conferencing Endpoint(except VC200) SN A MAC Reset or VC200 B PoE Note: The CTP18 supports 48V/0.27A PoE supply. Make sure of the connectivity between the CTP18 and endpoint. Otherwise, the CTP18 may not work properly. You can also connect the CTP18 to the VCM34, and then connect to the power and wired network.
Assemble your CTP18 SN Reset MAC 2 1 SN Reset MAC VCH 3 4 CTP18 Installation Put on a table You can place the system on the conference room table and adjust the touch screen as you need.
Mount on a Wall 100mm 1 2 3 4 5 6 If the conference room environment allows, you can also route the CTP18 through the wall. Start to Use the CTP18 After connected to the power and network, the CTP18 starts automatically. The CTP18 synchronizes the configurations from the endpoint and goes to the Home page. From the Home page, you can configure the ndpoint via the CTP18. For more information, refer to the user guide.