Installation Instructions

ManualsBrandsYardworks ManualsBuilding materialsBelmont 6 x 3-6 Tan Vinyl Privacy Gate

Planning is Essential

•

Consider soil conditions, slopes, utility locations

and property lines when positioning posts.

• Run a string line to locate the fence line and

establish the outside faces of your posts (See Fig 1.)

• Mark the centers of the post locations for your

gate. This Gate can accommodate openings

42.5" 43"space between two post.

Fig 1. Sample Staking & Post Layout

Item Product Name

A Gate Jambs

Striker

Latch

Hinged Bracket

Jamb Bracket

Stake

String

space

between

post

ost

Belmont Privacy Gate (6'x 3'6")

Installation Instructions

For SKU#

1728603,1728703

Required:

• Circular or Hand Saw with Fine Tooth Blade

• Measuring Tape

• Pencil/Marker

• 4" x 4" Treated Wood Post (2)

• Power Drill with 1/4" Drill Bit

• 7/16" Wrench

• Safety Glasses

• 2 Bar Clamps

Installation Tips:

• Prior to construction, check with your regulatory agency for local code requirements

• Contact your utility company to locate and mark underground lines

• Careful planning and measurement of your fence project is essential, as moving posts

after the concrete sets is extremely difficult

Jamb Cap

Through Bolts (16)

Self tapping screw (12)

Screws (12)

Rail

Fence Panel

42.5"- 43"

Summary of content (3 pages)

PAGE 1
Belmont Privacy Gate (6'x 3'6") Installation Instructions For SKU# 1728603,1728703 Required: • Circular or Hand Saw with Fine Tooth Blade • Measuring Tape • Pencil/Marker • 4" x 4" Treated Wood Post (2) • Power Drill with 1/4" Drill Bit • 7/16" Wrench • Safety Glasses • 2 Bar Clamps Installation Tips: • Prior to construction, check with your regulatory agency for local code requirements • Contact your utility company to locate and mark underground lines • Careful planning and measurement of your fence pro
PAGE 2
Setting Posts 1. Dig or auger post holes. The 4" x 4" Vinyl Posts require a 4" x 4" x 8' Treated Wood Post 10" DIAMETER HOLE, and must be at least 30" BELOW GRADE. In frost regions, the post holes should be deep enough to extend below the frost line. 2. The gate can be set up for Right or Left swing. The post that will be used as your Hinge Side MUST HAVE A 4" x 4" TREATED WOOD POST INSERT for greater strength. (See Fig 2.) Hinge Post 3.
PAGE 3
Installing Hardware 1. The Hinged Brackets (D) and Jamb Brackets (E) F should be located on the Gate Jamb in line with the Top and Bottom Rail. 2. Use the brackets as a guide and drill all holes, G being sure to pass through Gate Jamb and Top Bottom Rail. 3. Secure the Brackets using supplied nuts and bolts. Do not tighten fully. 4. Make sure the entire Gate assembly is square and tighten all bolts using a 7/16" wrench.