Save This Manual for Future Reference YARDMAN &= Two-Stage Snow Blower Operator's Manual MODEL NUMBER YB5765 SERIAL NUMBER L ] PURCHASE DATE Both mandrel number and serial number may be found on the wain label, You should record both of them in a safe place for future use.
Your new YARDMAX® snow blower offers quality construction, and is easy and safe to operate. With proper use and care, it is designed to give you many bears of dependable service. Prepare to experience the durability to take on any job with the ease, portability, and convenience of your new snow blower! Discover the YARDMAN Advantage AT YARDMAN, we understand that land ownership definitely has its privileges, but it also comes with a great deal of responsibility.
Cara fully read through this entire aerator's manual A before using your new unit, Pay attention to all cautions and warnings. This unit is a gasoline engine driven snow blower. It is perfect for tacking medium snowfall easily able to cut through snow in excess of a foot or more. It s easy and safe to operate. With proper use and care, it should give you many years of dependable service.
PERSONAL SAFETY Do not permit children to operate this machine at any time, seep children, pets, and other people not using the unit away From the work area. Be alert and shut off unit if anyone enters work area. Keep children under the watchful care of a responsible adult. Do not operate the machine while under the influence of drugs, alcohol, or any medication that could affect your ability to use it property. Dress properly. Wear heavy long pants, boots, and gloves.
Loosen the fuel tank cap showy to relieve any pressure in the dank. Never overfill the fuse dank. Fill the tank to no more than 1/27 below the bottom of the filler neck to provide space for expansion a5 the heat of the engine ¢an cause fuel fo expand, Replace all dual tank and container caps securely and wipe up spiffed fuel.
CONTENTS SUPPLIED Your YARDMAN snow blower comes partially assembled and contains the following: < / 1. Main Machine Eire Mex i “ 2. Control Panel 3. Handlebars . Mex Shift Lever e MéxX Chute Clean-Out Tool Er X3 6. Wheel Directional Chute Control cre X1 8. Discharge Chute 9. Chute Crank Flange e Maxima X2 B 10. Operator’s Manual & Engine Manual @ M8x20 X2 11 Tools for Spark Plug Assembly 12. Skid Shoes 13, Engine Ol 14. Plastic Skid Shoes (Optional) 15. Drift Cutters (Optical) 16.
e Gt Bl ASSEMBLY This snow bower was partially assembled sb the Victory To assertions your machine follow the below instructions. ENGINE AR FILTER COVER 5. Align the holes in fhe handlebars with the upper holes an both ‘sides of the transmission housing: Insert the bolts and carved: swashes and finger Habitat to hold in place. (See Pl 20) & Ensure the handlebars are at the same height, then tighten all 3 install siv Slater cover and tighten wing nut (See Fig we 1) Four bolts from the previous steps. 1.
Two-Stage Snow Blower » Operator’s Manual OPERATION FREEWHEELING AND SELF-PROPELLING Left wheel equipped with the axle lock pin can be completely retested by removing the pin and installing it in the outer pixie hole, Unlock the left wheel to allow for easier turning of the unit. Tor warlock the left wheel, remove the pin from the inner hole and insert the axle pin through the outer axle hole, but not through the withe hub.
SNOW BLOWING TIPS it Is easier and more efficient 1o remove snow immediately after it falls, The best Hume to remove stow is the sarky morning. AL this time the snow is usually dry and has not been exposed tithe direct sun and warming temperatures. Slightly overlap each successive path to ensure all snow will be rerecord. For large areas, start in the middies and throw snow to each side, so snow is not cleared more than once.