User's Manual

USER
S MANUAL
REMOTE GRILL
THERMOMETER
General Use Instructions
(Grill or Oven):
1.
Locate the battery compartments and load 2
AAA
batteries (not included)
into both Handheld Unit (Receiver) and Base Unit (T
ransmitter).
2.
Place Handheld unit in Base Unit cradle (units should be in close proximity
for establishing data link).
3. Place meat on grill or in oven.
4.
Insert stainless-steel meat probe into the thickest part of meat.
5.
Carefully
, replace/close grill lid or oven door on heat-resistant braided
steel probe wire.
6.
Plug probe wire into Base Unit.
7.
T
urn ON the Handheld Unit and Base Unit by locating both small
Ò
ON/OFF
Ó
switches.
8. Handheld Unit and Base Unit will establish data link automatically.
Registration is complete when the Handheld Unit beeps and the probe
temperature appears where the
Ò
---
Ò
was flashing.
9.
Once link is established, enter type of meat (Beef, V
eal, Lamb, Pork,
Chicken,
T
urkey) by pressing meat button on Handheld Unit until desired
meat is selected.
10.
Once meat type is selected, set desired taste level (Rare, Medium-Rare,
Medium, Well-Done) by pressing taste button on Handheld Unit until
desired taste/doneness level is selected.
11. To set the desired internal meat temperature manually: Press HR or MIN
button to raise or lower the temperature value after meat selection
is made.
12. Grill or Cook until alarm sounds indicating that the desired taste/doneness
level is reached. For best results set countdown/count up timer and check
meat periodically (see timer instructions).
13. Remove Meat from grill or oven and allow to cool (approx. 5 min.)
and serve.
Components:
Handheld Unit (Receiver)
Base Unit (T
ransmitter)
Stainless Steel Meat Probe
and Heat-resistant Probe Wire
Receiver Button Profiles:
1.
HR Button
: in timer mode, press to set hour
.
In thermometer mode, press to increase the
temperature value.
2.
CLEAR
: in timer mode, when the timer
countdown/count up process is stopped, press
to clear the timer reading.
3.
MIN
: in timer mode, press to set minutes.
In thermometer mode, press to decrease
temperature value.
4. MODE: press to select thermometer or timer
mode.
5.
MEA
T
: in thermometer mode press to select
meat type (BEEF
, LAMB, PORK,
CHICKEN,
TURKEY).
6. TASTE: in thermometer mode press to select
taste/doneness level (W
ELL. DONE,MED WELL,
MEDIUM, MED RARE, or RARE).
7.
ST
ART/ST
OP
: press to start or stop the timer
countdown or count up.
8.
ON/OFF
: switch on backside above clip
Ñ
turns receiver on and of
f.
9. SILVER SIDE BUTTON: press to turn LED
light on and of
f while receiver is ON (LED light
will not work while receiver power is OFF).
8
Power
Indicator
Light
Receiver Cradle
On/Off
Switch
Probe W
ire
Plug
Connector
BASE UNIT BOTT
OM
Battery
Cover
Timer Instructions:
Countdown Timer
1.
Press MODE to select timer mode.
The upper display
will show a small TIMER and 0:00.
2.
Press HR and MIN button to set the timer
. Press
ST
AR
T/ST
OP
button to start countdown timer
.
will blink for every second.
3.
T
o stop countdown timer
, press ST
AR
T/ST
OP
button again. The becomes solid.
4.
Press CLEAR button to clear the setting back to 0:00.
Count Up Timer
1. Press MODE to select timer mode. The upper display
will show a small
TIMER and 0:00.
2. Press START/STOP button to start count up. The
will blink for every second.
3.
T
o stop count up timer
, press ST
AR
T/ST
OP
button
again. The
becomes solid.
4.
Press CLEAR button to clear the setting back to 0:00.
LED Flashlight Instructions:
1. Press and hold silver button on side of Handheld Unit
for flashlight illumination while receiver switch is in the
ON position.
2. Release silver button to turn off.
Battery Replacement Instructions:
Handheld Unit (Receiver)
1.
Locate battery compartment underneath belt clip on the
backside of the Handheld Unit.
2.
Remove belt clip to access battery compartment (use
small Phillips head screwdriver).
3. Carefully, remove battery cover.
4.
Carefully
, load 2
AAA
batteries (not included).
5.
Replace battery cover and belt clip.
Base Unit (T
ransmitter)
1.
Locate battery compartment on
bottom side of Base Unit.
2.
Carefully
, remove battery cover
.
3.
Carefully
, load 2
AAA
batteries
(not included).
4.
Replace battery cover
.
Base Unit
(T
ransmitter)
T
roubleshooting:
Problem
:
Cannot Make Meat Selection.
Solution:
May be in
T
imer Mode. Check to make sure
that the Handheld Unit is in Thermometer Mode
by pressing
MODE
button.
Problem
:
No Data Link between Handheld Unit
and Base Unit.
Solution 1:
Check to make sure that both units are turned
ON while in close proximity to one another
.
Solution 2:
Check Batteries for replacement.
Problem: Flashlight will not work.
Solution 1:
Make sure receiver switch is in the ON position
and press flashlight button on the side of the
Handheld Unit.
Solution 2: Check batteries for replacement.
Cleaning Instructions:
1. Hand wash probe gently with soap and water.
2. DO NOT
immerse probe in water while cleaning.
3. Dry immediately.
4. DO NOT
W
ASH Handheld Unit or Base Unit.
5. NOT DISHWASHER SAFE.
Helpful Hints:
1. For best results, make sure probe tip is inserted into the
meat a least 1 inch.
2. Do not allow the probe or probe wire to come in direct
contact with flames. If cooking with grill cover closed,
only use medium and low heat.
3.
Make sure that probe tip is inserted into the center of
meat (NOT
poking through meat).
Caution:
1.
Caution Meat Probe and Probe Wire are very hot
while in use.
2.
Always use a heat-resistant glove when handling meat
probe or probe wire while in use. DO NOT touch with
bare hands.
3.
DO NOT
expose Handheld/Base Unit to direct heat
or hot surfaces.
4.
NOT
FOR USE IN MICROW
A
VE OVENS.
5. DO NOT expose Base Unit/Probe plug connector
to water
.
6. DO NOT use Handheld/Base Unit in the rain.
NOT
W
A
TERPROOF
.
7.
Base Unit registers temperatures as low as 30 F
and as
high as 410 F . Do not use stainless steel probe sensor
above 410 F
. If 410 F
is exceeded probe wire may
deteriorate.
8. This product is intended for use as a meat thermometer.
NOT INTENDED FOR USE AS AN EXTERNAL OVEN
THERMOMETER.
9.
Keep Stainless Steel Probe/Wire away from Children.
Receiver
Back
Battery
Cover
Belt Clip
Battery Replacement Instructions: