UC English YID-W10 Wireless System for iPod Système sans fil pour iPod OWNER’S MANUAL MODE D’EMPLOI Français
FCC INFORMATION (for US customers) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructions.
Caution: Read this before operating this unit. 1 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2 Locate this unit away from other electrical appliances, motors, or transformers to avoid humming sounds. 3 Do not expose this unit to sudden temperature changes from cold to hot, and do not locate this unit in an environment with high humidity (i.e.
Introduction 1: Connection YID-W10 is a wireless system designed for iPod/ iPhone series. YID-W10 employs the Yamaha “yAired” technology to establish a wireless connection with another Yamaha dock-compatible component (hereinafter referred to as “Yamaha component”) that supports “yAired” and enables playback of the iPod/iPhone audio on your Yamaha component. For video, enjoy it on your iPod/iPhone display.
3: Playback 1 Connect your iPod/iPhone to the transmitter. The green LED on the transmitter (YIT-W11TX) and blue LED on the receiver (YIR-W10) light up if a wireless connection between the transmitter and receiver is established. 2 Start playback on your iPod/iPhone. Operation and function depend on your iPod/ iPhone model and Yamaha component. Refer to the owner’s manuals supplied with your iPod/ iPhone and Yamaha component.
4: Battery charge To charge your iPod/iPhone, connect it to the transmitter, and then station the transmitter with your iPod/iPhone onto the receiver. Note Do not push the transmitter detection switch hard. Transmitter detection switch 12 A 12 A 3 B 3 B Troubleshooting If the unit does not function properly, first of all, check the firmware of your iPod/iPhone is the latest version. If it is the latest version, refer to the table below.
Transmitter LED Green: flashes Problem Cause Remedy There is a device (microwave oven, cordless phone, Wi-Fi, etc.) outputting signals in 2.4 GHz frequency band nearby. Move YID-W10 away from the device. The signal from the transmitter is blocked by your body, metallic objects, or wall, etc. Change the position of the transmitter to avoid the object blocking the signal. The position of the transmitter is too far from the receiver. Move the transmitter closer to the receiver. No sound.
Transmitter LED Green: lights up Problem No sound Cause Remedy The volume is set to the minimum. Set the volume properly. Your Yamaha component is turned off. Turn on your Yamaha component. The input source of your Yamaha component is not set properly. Set the input source properly. Earphones or other device are connected to your iPod/ iPhone. Disconnect earphones or other device. The volume of iPod/iPhone does not change when you operate the volume of your Yamaha component.
Specifications Supported iPod (as of April 2010) .... iPod (5th generation), iPod classic, iPod nano, iPod touch Supported iPhone (as of April 2010) ...........................iPhone, iPhone 3G, iPhone 3GS Frequency ................................................... 2.4 GHz Transmission Range .................Approx. 20m (66 ft) (without interference) Number of units which can be simultaneously transmitted to (YIT-W11TX) ...Up to 7 units (depending on the circumstances) Latency ............................
© 2010 Yamaha Corporation Printed in China WV30490
