YAS-109 / ATS-1090 Update Guide EN
Table of contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.1. Equipment required for firmware update . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.2. Preparing the firmware. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. Introduction 1. Introduction This Guide provides instructions for updating firmware with a USB flash drive on the following products. • YAS-109 • ATS-1090 ◦ Sold only in certain countries or regions See product pages on the Yamaha website for details regarding the issues resolved, and functions added, by updating firmware. 1.1. Equipment required for firmware update Prepare the following items before attempting to update firmware.
2. Updating the unit’s firmware 2. Updating the unit’s firmware Update the firmware of the unit. 1. Turn off the unit. 2. Unplug the power cable from the AC wall outlet. 3. Connect the USB flash drive to the UPDATE ONLY jack on the unit. USB flash drive containing the firmware data file 4. Plug the power cable into an AC wall outlet. 5. Touch and hold (volume -) and (power) together for at least 3 seconds. The firmware update begins.
2. Updating the unit’s firmware Note • When the firmware version of the unit is newer than the firmware to be installed, the update does not begin.
3. Troubleshooting 3. Troubleshooting If the firmware update fails, the indicators will flash as illustrated below. Confirm the problem and try updating the firmware again. 3.1. Flashing (red) indicator Flashes (red) 3.1.1. The USB flash drive is not connected to the unit correctly. 1. Terminate the update by touching (power). 2. Connect the USB flash drive to the unit correctly. 3. Try updating the firmware again. 3.1.2. The firmware data file was not properly saved to the USB flash drive. 1.
3. Troubleshooting 3.2.1. The power cable was unplugged while firmware was being updated. 1. Plug the power cable into an AC wall outlet. 2. Be sure that the USB flash drive is correctly connected to the unit. 3. Touch (power). The firmware update will resume. 3.2.2. A power failure occurred. 1. Be sure that the USB flash drive is correctly connected to the unit. 2. Touch (power). The firmware update will resume.
Manual Development Group © 2019 Yamaha Corporation Published 04/2020 YJ-D0