User Manual

RX-V573

In case of error, see the

Troubleshooting

section

IMPORTANT NOTICE

Do not attempt to update your Yamaha receiver using any other data file except those provided directly from the

Yamaha website or through your network connection.

Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by

Yamaha.

Improperly updated products may cause improper operation, and any parts or service required to restore proper

operation will not be covered under the Yamaha Limited Warranty.

FIRMWARE UPDATING PROCEDURE

Requirement:

USB thumb drive, with enough free space to store over 25MB.

(File system with FAT16 or FAT32 format)

Firmware file provided by YAMAHA, “R0305-xxxx.bin”.

Prepare USB thumb drive for the update

Download the firmware, unzip and copy “R0305-xxxx.bin” into the root directory of the USB thumb drive.

Dra

& Dro

the file into USB thumb drive.

Power off the receiver (Standby mode)

Insert the USB thumb drive

USB port is located at the lower left corner of the front panel.

Enter the ADVANCED SETUP mode

While pressing the

STRAIGHT

key, press the

(power)

key and keep

STRAIGHT

key pressed until

“ ADVANCED SETUP ” appears on the front panel display.

PAGE 1
RX-V573 FIRMWARE UPDATING PROCEDURE IMPORTANT NOTICE Do not attempt to update your Yamaha receiver using any other data file except those provided directly from the Yamaha website or through your network connection. Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by Yamaha.
PAGE 2
RX-V573 5 Select firmware update from the menu Press the PROGRAM key until “UPDATE.....USB ” is displayed. STRAIGHT key (power) key USB port PROGRAM key 6 Start firmware update a. Press INFO key to start the update. (Update process may take up to 10 minutes) * If “ UPDATE SUCCESS ” appears, this means your receiver is already up-to-date. In this case, power off to exit from Advanced Setup. Your AV receiver is ready for normal use.
PAGE 3
RX-V573 Troubleshooting CASE 1 Error message appeared during the update Cause: Method: For some reason, the receiver can’t read the firmware data. For your solution, check the following ❏USB thumb drive is connected properly to the receiver. ❏USB thumb drive is not password protected. (AV receiver cannot read data from a security protected USB thumb drive) ❏Make sure the USB thumb drive is inserted before the receiver is powered on for the update. ❏The firmware data, R0305-xxxx.