UA Receiver OWNER’S MANUAL EN
IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
IMPORTANT SAFETY INSTRUCTIONS FCC INFORMATION (for US customers) 1 IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2 IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used.
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this sound system in a well ventilated, cool, dry, clean place - away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. For proper ventilation, allow the following minimum clearances around this unit.
CONTENTS USEFUL FEATURES............................................... 1 SUPPLIED ACCESSORIES.................................... 1 LISTENING TO MUSIC FROM YOUR Bluetooth DEVICE...................................................13 Playing back from your Bluetooth device .................. 13 Connecting an already-paired device via Bluetooth ... 14 Disconnecting a Bluetooth connection ....................... 14 CONTROLS AND FUNCTIONS ............................ 2 Front panel..............................
CONTROLS AND FUNCTIONS Front panel 1 2 3 45 6 7 8 9 0 BAND A 1 B C D A (power) Turns this unit on, or sets it to standby mode. 2 FM MODE Changes the FM radio wave reception mode (stereo or monaural) when TUNER is selected as the input source (see page 15). 3 Remote control sensor Receives infrared signals from the remote control. 4 STANDBY/ON indicator Indicator Status Brightly lit The power of this unit is “on”. Dimly lit This unit is in “standby” mode.
CONTROLS AND FUNCTIONS A PHONES jack For connecting headphones. y Press SPEAKERS A/B so that the SP A/B indicators (see page 4) turn off before you connect your headphones to the PHONES jack. B SPEAKERS A/B Turns on or off the speaker set connected to the SPEAKERS A and/or SPEAKERS B terminals on the rear panel each time the corresponding button is pressed (see page 12). C BASS –/+ Increases or decreases the low frequency response.
CONTROLS AND FUNCTIONS Front panel display 1 PRESET indicator Lights up or blinks when using the preset function (see page 16). 4 TUNED indicator Lights up when this unit is tuned in to an FM or AM station with a strong signal. 2 MEMORY indicator Lights up or blinks when registering radio stations as presets (see page 16). 5 SLEEP indicator Lights up when the sleep timer is turned on (see page 12). 3 SP (SPEAKERS) A/B indicators Light up according to the set of speakers selected.
CONTROLS AND FUNCTIONS Rear panel 1 2 3 4 5 6 7 1 ANTENNA terminals Used to connect the radio antennas (see page 11). 6 SPEAKERS terminals Used to connect speakers (see page 9). 2 Power cable For connecting this unit to an AC wall outlet (see page 11). 7 VOLTAGE SELECTOR (Only for General model) 3 CD jacks Used to connect a CD player (see page 9). 4 LINE 1-2 jacks Used to connect audio components (see page 9).
CONTROLS AND FUNCTIONS Remote control 4 Input selector buttons Select the input source you want to listen to. 1 y 2 3 4 The input source names correspond to the names of the connection jacks on the rear panel. SLEEP LINE 1 LINE 2 LINE 3 CD TUNER BAND MEMORY TUNING TREBLE 6 BASS D INFO PRESET 5 5 TREBLE –/+ Increases or decreases the high frequency response.
CONTROLS AND FUNCTIONS ■ Radio function controls ■ Bluetooth controls D TUNING jj / ii Selects the tuning frequency (see page 15). 8 Bluetooth control buttons BLUETOOTH Switches the audio source to Bluetooth I Skips backward I Skips forward II Starts/pauses playback The following buttons can be used when TUNER is selected as the input source. PRESET j / i Selects a preset radio station (see page 17). BAND Switches the radio tuner band.
CONTROLS AND FUNCTIONS Using the remote control ■ Installing batteries Change all batteries if you notice the operation range of the remote control narrows. Before inserting new batteries, wipe the battery compartment clean. ■ Operation range Point the remote control at the remote control sensor on this unit and remain within the operating range shown below. The area between the remote control and this unit must be clear of large obstacles.
CONNECTIONS Connecting speakers and source components Make sure to connect L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. Refer to the owner’s manual for each of your components. Make sure to use RCA cables to connect audio components.
CONNECTIONS ■ OUT jacks • The OUT jacks output audio signals of the currently selected input (except when LINE 3 is selected). • Volume level, tone control and balance settings do not affect the OUT jacks. ■ Connecting speaker cables ■ Bi-wire connection Bi-wire connection separates the woofer from the combined midrange and tweeter section. A bi-wire compatible speaker has four binding post terminals. These two sets of terminals allow the speaker to be split into two independent sections.
CONNECTIONS Connecting the FM/AM antennas Connect the supplied FM/AM antenna to this unit. Fix the end of the FM antenna to a wall, and place the AM antenna. FM antenna AM antenna Connecting power cable Plug the power cable into an AC wall outlet after all other connections are complete. CAUTION Only for General model: Before connecting the power cable, make sure you set VOLTAGE SELECTOR of this unit according to your local voltage.
PLAYBACK Playing a source 6 When finished listening, press A (power) to set this unit to standby mode. Press A (power) to turn this unit on again. y • You can also use the buttons or knobs on the front panel if they have the same or similar names as those on the remote control. • For recording, see page 5.
LISTENING TO MUSIC FROM YOUR Bluetooth DEVICE This unit provides Bluetooth functionality. You can enjoy wireless music playback from your Bluetooth device (mobile phone, digital audio player, etc.). Please also refer to the owner’s manual of your Bluetooth device. Playing back from your Bluetooth device 3 You’ll need to perform the pairing operation the first time you use your Bluetooth device with this unit, or if the pairing settings have been deleted.
LISTENING TO MUSIC FROM YOUR Bluetooth DEVICE Connecting an already-paired device via Bluetooth Once pairing has been completed, connecting a Bluetooth will be easy the next time. ■ Connecting from the Bluetooth device 1 In the Bluetooth settings of the Bluetooth device, turn Bluetooth on. 2 From the Bluetooth connection list of the Bluetooth device, choose this unit (R-S202 Yamaha). The Bluetooth connection will be established, and the front panel display of this unit will indicate “CONNECTED”.
FM/AM TUNING You can tune in to a radio station by specifying its frequency or selecting from registered radio stations. Notes • The radio frequencies differ depending on the country or region where this unit is being used. Front panel display illustrations shown in this section are based on Europe model. • Only for Asia and General models: Be sure to set the tuner frequency step according to the frequency spacing in your area before you tune in to a radio station (see page 19).
FM/AM TUNING 1 Press TUNER to select the tuner as the input source. 1 Tune in to the desired FM/AM station. See page 15 for tuning instructions. 2 Press BAND to select the FM band. 2 3 Press MENU to enter the Option menu. The Option menu for TUNER is displayed (see page 19). Press MEMORY. “MANUAL PRESET” is displayed briefly on the front panel display, and then the preset number to which the station will be registered is displayed. 4 Press / to select “AUTO PRESET”, and then press ENTER.
FM/AM TUNING ■ Recalling a preset station You can recall preset stations that were registered by presetting automatically or manually. ■ Clearing a preset station Follow the steps below to clear a preset station.
FM/AM TUNING 6 Press ENTER again to confirm. “CLEARED” is displayed on the front panel display. Then, another preset station is shown on the front panel display. When there is no more preset station, “NO PRESET” is displayed, and then the display returns to the Option menu. To return the display to the original state, press MENU. ■ Clearing all preset stations Follow the steps below to clear all preset stations. 1 Press TUNER to select the tuner as the input source.
SETTING THE OPTION MENU FOR EACH INPUT SOURCE The Option menu allows you to configure various settings for each input source and recall those settings automatically when an input source is selected. 1 Press one of the Input selector buttons to select the desired input source. 2 Press MENU. 3 Press / to select the desired menu item, and then press ENTER. 4 Press / to change the settings, and then press ENTER.
TROUBLESHOOTING Refer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or if the instructions below do not help, set this unit to standby mode, disconnect the power cable, and then contact the nearest authorized Yamaha dealer or service center. ■ General Problem Cause Remedy See page The power cable is not connected or the plug is not completely inserted. Connect the power cable firmly.
TROUBLESHOOTING Problem Cause The sound is degraded when listening with headphones connected to a CD player connected to this unit. This unit has been set to standby mode. The remote control does not work nor function properly. Wrong distance or angle. Remedy See page Turn on the power of this unit. 12 The remote control will function within a maximum range of 6 m (20 ft) and no more than 30 degrees offaxis from the front panel.
TROUBLESHOOTING Remedy See page Problem Cause No sound is produced or the sound is interrupted during playback. The Bluetooth connection of this unit with the Bluetooth device is disconnected. Perform Bluetooth connection operations again. This unit and the Bluetooth device are too far apart. Move the Bluetooth device closer to this unit. There is a device (microwave oven, wireless LAN, etc.) outputs signals in the 2.4 GHz frequency band nearby.
SPECIFICATIONS AUDIO SECTION FM SECTION • Minimum RMS output power (8 , 40 Hz to 20 kHz, 0.2% THD) [North America, General, China, Korea, Australia and Europe models] ................................................. 100 W + 100 W [Asia model] ......................................................... 85 W + 85 W • Dynamic power per channel (8 6 4 2 IHF) ....................................................... 125 W/150 W/165 W/180 W • Maximum power per channel (4 1 kHz, 0.
Yamaha Global Site http://www.yamaha.com/ Yamaha Downloads http://download.yamaha.
OYAMAHA II as~cstt ~§6(L:J:fJ, IJ:r=:JYO)~~fuO).Afl7Jb'~~fJ*9 ( 5-17 IDJ@
II Advertencia Mededeling El metoda para Ia instalaci6n de las pilas en el mando a distancia varia dependiendo del producto (tipo ® o tipo @). Identifique primero el tipo de mando a distancia suministrado y despues inserte las pilas como se indica en Ia figura correspondiente. De methode voor het plaatsen van de batterijen in de afstandsbediening varieert afbankelijk van het product (type ® of@).
MIDDLE EAST - -~ TURKEY I CYPRUS Yamaha Music Europe GmbH Siemensstrasse 22-34, 25462 Rellingen, Germany I ASIA SINGAPORE Yamaha Music (Asia) PRIVATE LIMITED Blk 202 Hougang Street 21, #02-00, Singapore 530202, Singapore THE PEOPLE'S REPUBLIC OF CHINA Yamaha Music & Electronics (China) Co.,Ltd. 2F, Yunhedasha, 1818 Xinzha-lu, Jingan-qu, Shanghai, China TAIWAN Yamaha Music and Electronics Taiwan Co., Ltd. 2F., No.1, Yuandong Rd. Banqiao Dist.
OYAMAHA For details of products, please contact your nearest Yamaha representative or the authorized distributor listed below. Pour plus de details sur les produits, contactez votre representant Yamaha le plus proche de chez vous ou le distributeur agree indique ci-dessous. NORTH AMERICA ----~ CANADA Yamaha Canada Music Ltd. 135 Milner Avenue, Tronto ON M1S 3R1, Canada U.S.A. Yamaha Corporation of America 6600 Orangethorpe Ave., Buena Park, Calif. 90620, U.S.A.
eYAMAHA Registering Your New Yamaha Product is Fast and Easy Thank you for purchasing a new product from Yamaha Electronics. We'd like to continue providing you with high quality products and better service. So, we've made it simple to register your new product purchase online. Please take a few minutes to visit our.website at www.yarnaha.com/YEC/registration/ and complete the information and questions included there. We appreciate your business and we look forward to hearing from you.
OYAMAHA LIMITED WARRANTY ON HOME AUDIO PRODUCTS Thank you for selecting a YAMAHA product. YAMAHA products are designed and manufactured to provide a high level of defect-free performance. Yamaha Corporation of America ("YAMAHA") is proud of the experience and craftsmanship that goes into each and every YAMAHA product.
